Digunakan untuk merubah tegangan 220V AC menjadi 12V DC. Beberapa contoh barang yang menggunakan 12V DC : Lampu LED, LED Module, Strip LED, CCTV, Lampu Halogen dan sebagainya
FULL LOAD (100% Murni penggunaan Watt)
Fakta parameters :
1. Input Voltage : 100 - 265 V AC 2. Built - in EMI Filter 3. 100% Full-Load test, 100% burn-in tested 4. Output Voltage accurate and stable (output over voltage, over current and short circuit protection) 5. Output low ripple and noise 6. MTBF : 50,000 Hours 7. Input Frequency : 50/60 Hz 8. Input Surge : Cold start /230 V AC / 2.5A. Max 9. Inrush Current : 40A 10. Dimension : 231 mm (Length) x 153 mm (Width) x 65 mm (Height) 11. Cooling method : Natural Cooling air convection 12. Net weight : 725 gram 13. Ripple Noise : 100 mV 14. Efficiency : 83% 15. IP55 (Tahan terhadap Hujan). Harus diinstallasi dengan rapi. 16. Output : DC 12V / 25A / 300 Watt (MURNI)
OUTPUT SPECIFICATION : Adjustable Voltage : +- 10% Start up time : 1S (input 230V, Io = 100%) Keep time : 20mS (input 230V, Io=100%) Voltage regulation : (Full load) < 0.5%
PROTECTION FUNCTION :
Cut-off Mode, Output Shuts down if over-loaded Recovers automatically after fault condition is removed Overload protection : 105%- 150% rated power, automatic recovery Over-Voltage protection : 105% - 150% of the rated voltage
SAFETY STANDARDS :
According with EN 61347-2-13
PERINGATAN :
1. Agar voltage output tidak turun, diusahakan pemasangan Power Supply dekat dengan sumber tenaga (listrik PLN). 2. Apabila harus jauh dari sumber tenaga, maka gunakan kabel yang lebih tebal dan penggunaan jangan 100% tenaga (Recommended 70%)