Caddock MP930 Power Film Resistor TO-220

Caddock MP930 Power Film Resistor TO-220
Low Cost Heat Sink Mountable Design featuring an Exposed Ceramic Heat Dissipating Mounting Surface
Up to 30 Watts at +25°C Case Temperature, derated to zero at +150°C.
Exposed Ceramic Heat Dissipating Mounting Surface.
Non-Inductive Design.

TC referenced to +25°C, ΔR taken at +150°C
0.50 ohms and above, -20 to +80 ppm/°C
0.050 ohm to 0.49 ohms, 0 to +200 ppm/°C
0.020 ohm to 0.049 ohm, 0 to +300 ppm/°C
0.010 ohm to 0.019 ohm, 0 to +500 ppm/°C

Inductance: 10 nH typical
DWV: The dielectric strength rating of 1500 VrmsAC is based upon connections made between terminals shorted, and the metal surface the part is mounted to or a metal clip in contact with the top surface of the part.
Insulation Resistance: 10,000 Megohms min.The resistor element is electrically isolated from
the mounting surface.
Load Stability: 2,000 hours at rated power.ΔR ±(1.0 percent + 0.0005 ohm) max.
Power rating dependent upon case temperature. See derating curve.
Momentary Overload: 1.5 times rated power with applied voltage not to exceed 1.5 times maximum continuous operating voltage for 5 seconds. ΔR ±(0.5 percent + 0.0005 ohm) max.
Moisture Resistance: Mil-Std-202, Method 106. ΔR ±(0.5 percent + 0.0005 ohm) max.
Thermal Shock: Mil-Std-202, Method 107, Cond. F. ΔR ±(0.5 percent + 0.0005 ohm) max.
Shock: 100G, Mil-Std-202, Method 213, Cond. I. ΔR ±(0.4 percent + 0.0005 ohm) max.
Vibration, High Frequency: Mil-Std-202, Method204, Cond. D. ΔR ±(0.4 percent + 0.0005 ohm) max.
Terminal Strength: Mil-Std-202, Method 211, Cond. A (Pull Test) 5 lbs. ΔR ±(0.2 percent + 0.0005 ohm) max.
Terminal Material: Solderable

Nilai yang tersedia:

1K5 ; 30W ; 1%

Rating power 30W hanya akan tercapai bila menggunakan Haetsink yang memadai.