Esp32 Cam Ov2640 Camera Wifi Bluetooth Arduino Esp32S Kamera Esp-32

Wellcome.. Selamat berkunjung, semoga yang Anda cari ada di sini.. Modul teknis hanya bagi yang mahir, paket ESP32 + Camera OV2640 The ESP32CAM is a tiny module based on ESP32 chip and OV2640. You can even program the ESP32CAM through the ESP-IDF by installing the ESP32 Core. The ESP32CAM equips the ESP32 with everything necessary to program, run and develop on the wonderchip. It also features a LiPo charger (IP5306), so your ESP32CAM project can be battery-powered and truly wireless. Additionally, the board reserved the MPU6050,BME280 and an analog MIC. Using low-power Dual-Core 32-bit CPU, as an application processor The main frequency is up to 240MHz, and the computing power is up to 600 DMIPS Built-in 520 KB SRAM, external 4M PSRAM Support UART/SPI/I2C/PWM/ADC/DAC and other interfaces Support OV2640 and OV7670 cameras, built-in flash Support picture WiFi upload Support TF card Support multiple sleep modes Embedded Lwip and FreeRTOS Support STA/AP/STA+AP working mode Support Smart Config/AirKiss one-click network configuration Support secondary development **Spesifikasi: Dual-core Tensilica LX6 microprocessor Up to 240MHz clock frequency 520kB internal SRAM 4MB Flash memory Integrated 802.11 BGN WiFi transceiver Integrated dual-mode Bluetooth (classic and BLE) Hardware accelerated encryption (AES, SHA2, ECC, RSA-4096) CP2104 USB TTL OV2640 sensor Output Formats(8-bit): YUV(422/420)/YCbCr422 RGB565/555 8-bit compressed data 8-/10-bit Raw RGB data Maximum Image Transfer Rate UXGA/SXGA: 15fps SVGA: 30fps CIF: 60fps Scan Mode: Progressive Camera specifications CCD size: 1/4inch Field of View: 78 degree Maxmium Pixel: 200W Sensor best resolution: 1600 * 1200 Dimension: 25mm x 24mm Weight: 5g **KESALAHAN yang sering terjadi : (1) user tidak memasang jumper ke GND untuk mengubah mode kerja ESP32 sehingga gagal upload. (2) user tidak menekan tombol RESET saat Arduino IDE selesai upload, dan meminta ada HARD RESET Terimakasih