NuMicro ICP programmer Nu-Link Nuvoton ICP Emulator

NuMicro ICP programmer Nu-Link Nuvoton ICP Emulator Selama Barang/Produk Masih Tayang/Aktif Berarti (Stok Tersedia), Bisa Langsung Di Order/Di Beli (Tidak Perlu Chat Toko). Masukkan Keranjang Lalu Bayar. Saat itu Juga Barang/Produk Langsung Kami Kirim. Semua Produk Di Toko Kami Pre Order 6 - 15 Hari Tergantung Stok dan Posisi Gudang Luar Negeri. Anda Order Berarti Anda Setuju Dengan Waktu Pre Order Yang Kami Tetapkan Secara Default 6 - 15 Hari. Features:;- In-Circuit programming target chip- Online/offline programming mode- Backup flash data of target chip (If the target chip is not flash protected)- Backup offline flash data of Nu-Link dongle (if offline data has been unprotected)- Write software serials number (SN) to target chip- Limit the maximum programming count- Data encryption for online/offline programming- Batch mode for online/offline programming;Preparing for ICP Programming Tool:;2.1 System RequirementsThe hardware and software requirements for installing the ICP Programming Tool systemare as follows:PC/AT compatible machine with Pentium or higher CPUXVGA(1024*768) color monitorAt least 512M RAM for best performanceAt least 20M free disk spaceWindows 2000/XP/Vista/72.2 Hardware InstallationStep 1: Plug USB cable into the USB port of the ICP Programming Tool board.Step 2: Connect the ICP Programming Tool board with ICE interface of DEV board.2.3 Software InstallationPlease run the installer package to install the software;Operation Modes of ICP Programming Tool and Nu-Link Dongle:;3.1 ICP Programming Tool ModesThe ICP tool supports “online” and “offline” programming mode.3.1.1 Online Programming ModeIf the “Offline programming mode” option in Figure 4-14 is unchecked, ICPProgramming Tool will program in online programming mode.Click the “Start” button in Figure 2-2 to start to program target device immediately.The target device must be connected to SKU1440646