Arducam 16MP Autofocus Camera Module Raspberry Pi or Jetson Nano / NX - Case Only

𝐍𝐎𝐓𝐄: 𝐓𝐈𝐃𝐀𝐊 𝐌𝐄𝐍𝐄𝐑𝐈𝐌𝐀 𝐊𝐋𝐀𝐈𝐌 𝐀𝐓𝐀𝐔 𝐊𝐎𝐌𝐏𝐋𝐀𝐈𝐍 𝐃𝐈 𝐋𝐔𝐀𝐑 𝐒𝐈𝐒𝐓𝐄𝐌 𝐓𝐎𝐊𝐎𝐏𝐄𝐃𝐈𝐀


SKU: KE3023/B0371

Specfication & Comparison Chart

Sensor: Sony IMX519 stacked, back-illuminated sensor 16 megapixels 1.22 µm × 1.22 µm pixel size7.103 mm diagonal (Type 1/2.534)
Output: RAW10/8, COMP8
Lens: Autofocus; f/1.75; EFL: 4.28; FoV: 80°; Focus Range: 10 cm ~ infinite
IR cut Filter: Integrated
Tripod mount: 1/4”-20
Enclosure: ABS, also compatible w/ camera module v1 & v2.
Ribbon Cable Length: 150mm

Safety instructions

Before connecting, you should always power the Raspberry Pi off and remove the power supply first.
Make sure the cable on the camera board is locked in place.
Make sure the cable is correctly inserted in the Raspberry Pi board’s MIPI CSI-2 connector.
Avoid high temperatures.
Avoid water, moisture, or conductive surfaces while in operation.
Avoid folding, or straining the flex cable.
Avoid cross-threading with tripods.
Gently push/pull the connector to avoid damaging the printed circuit board.
Avoid moving or handling the printed circuit board excessively while it’s in operation.
Handle by the edges to avoid damages from electrostatic discharge.
Sudden temperature/humidity changes can cause dampness in the lens and affect the image/video quality.

*Support NVIDIA Jetson board, Raspberry Pi Zero, Pi 4 dan Pi 5

Packing List
1 x Arducam 16MP-AF Camera Module
1 x 22pin to 22pin FPC Cable (15cm) for Pi 5, Pi Zero
1 x 15pin to 22pin FPC Cable (15cm) for Pi 4B, 3B+