GEOX-M10 ublox M10050-KB based GNSS GLOSNASS GPS Beidou untuk arduino Ardupilot Apm Pixhawk PX4 Betaflight iNav drone FPV

The extremely low power consumption of less than 25mW in continuous tracking mode allows great power autonomy for all battery-operated devices, such as asset trackers, without compromising on GNSS performance. The GEOX-M10 supports concurrent reception of four GNSS (GPS, GLONASS, Galileo, BeiDou). The high number of visible satellites enables the receiver to select the best signal. This maximizes the position availability, especially in challenging conditions, such as in deep urban canyons.

The GEOX-M10 adopts super-S technology, which offers great RF sensitivity and can improve the dynamic position accuracy by up to 25% with small antennas or in a non-line-of-sight scenario.

The GEOX-M10 module integrates an LNA followed by a SAW filter in the RF path for maximum sensitivity in passive antenna designs. GEOX-M10 offers a cost and power optimized setup without LNA and SAW filter. Advanced filtering algorithms mitigate the impact of RF interference and jamming, thus enabling the product to operate as intended.

Features：
● Build on newest high performance, high accuracy, low-power consumption UBX-M10050-KB chipset
● Ultra high sensitivity: -167dBm
● Extremely fast TTFF at low signal level
● Built in high gain LNA
● Ultra-low power consumption:Max25mA@3.3V
● Higher Position Accuracy: 1.5m CEP
● NMEA-0183 compliant protocol or custom protocol
● Operating voltage: 3.0V--5.0V
● Operating temperature range:-40 to 85℃
● Patch Antenna Size: 25x25x4mm ceramic antenna
● Communication type: UART TTL Level
● Wire interface type:1.25mm 4Pin connector
● RoHS compliant (Lead-free)

sangat cocok di pakai pada flight control untuk drone dan UAV, support betaflight, iNav, Arduplane, APM/PIXHAWK

Paket terdiri :
● 1 module GPS GEOX-M10
● 1 x 4 pin wire DF13 (VCC, GND, TX, RX)