4.9/ 5.0
100% pembeli merasa puas
17 rating • 2 ulasan
5(16)94.12%
4(1)5.88%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 99945
Subtotal
Rp19.000
DRV8825 3D Printer CNC Stepper Motor Driver For RAMPS CNC Shield
Rp19.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: 3D Printer / CNC Part
Keunggulan dibanding A4988 driver :
1. the maximum current of 2.5A.
2. up to 32 segments.
3. 4-layer PCB, better heat dissipation.
4. the chip resistance is smaller, less heat, and better heat dissipation.
Parameters:
Size: 1.5mmX2mm (and the same 4988)
Can drive currents: 2.5A
Segmentation: 1,1 / 2,1 / 4,1 / 8,1 / 16,1 / 32
Manufacturing Process: SMT placement machine higher manufacturing, non-manual welding, yield more stable performance
Suitable for:
Need to drive stepper motors.
It is to build a 3d printer, cnc, engraving machine and other essential modules.
Supported 3d printers have Prusa Mendel, ultimaker, printbot, makerbot like.
You can refer back Arduino code, direct drive motor
DRV8825 features are the following:
1, suitable for driving below 8.2V ~ 45V 2.5A stepping motor;
2, only a simple step and direction control interface;
3, six different stepping modes: full, half, 1 / 4,1 / 8,1 / 16,1 / 32;
4, adjustable potentiometer can adjust the maximum current output, resulting in higher step rate;
5. Automatic current decay mode detection / selection;
6, thermal shutdown circuit, undervoltage lockout, crossover current protection;
7, ground short-circuit protection and load short circuit protection
1. the maximum current of 2.5A.
2. up to 32 segments.
3. 4-layer PCB, better heat dissipation.
4. the chip resistance is smaller, less heat, and better heat dissipation.
Parameters:
Size: 1.5mmX2mm (and the same 4988)
Can drive currents: 2.5A
Segmentation: 1,1 / 2,1 / 4,1 / 8,1 / 16,1 / 32
Manufacturing Process: SMT placement machine higher manufacturing, non-manual welding, yield more stable performance
Suitable for:
Need to drive stepper motors.
It is to build a 3d printer, cnc, engraving machine and other essential modules.
Supported 3d printers have Prusa Mendel, ultimaker, printbot, makerbot like.
You can refer back Arduino code, direct drive motor
DRV8825 features are the following:
1, suitable for driving below 8.2V ~ 45V 2.5A stepping motor;
2, only a simple step and direction control interface;
3, six different stepping modes: full, half, 1 / 4,1 / 8,1 / 16,1 / 32;
4, adjustable potentiometer can adjust the maximum current output, resulting in higher step rate;
5. Automatic current decay mode detection / selection;
6, thermal shutdown circuit, undervoltage lockout, crossover current protection;
7, ground short-circuit protection and load short circuit protection
Ada masalah dengan produk ini?