Fluke LIQ100 Networks LinkIQ Cable Network Tester LIQ-100 Link IQ VLAN

Specifications: Fluke Networks LinkIQ Cable+Network Tester

FeatureDescriptionLanguages supported in UIEnglish (SW v1.0)Weight1 lbs 6 oz (624g)BatteryType: Lithium-ion, 3.6 V, 6400 mAh
Life: 8 hours typical
Charge time: 4.5 hours
Charging temperature range: 0 °C to +40 °CPower AdapterInput: 100 to 240 VAC ±10%, 50/60Hz
Output: 15 VDC, 2 A maximum
Class IIHost InterfaceUSB type CDisplay800 x 480 color capacitive multi-touchDimensions8.5 in x 4.5 inOperating Temperature0°C to 45°CStorage Temperature-10°C to +60°COperating Relative Humidity0 % to 90 %, 0°C to 35°C
0 % to 70 %, 35°C to 45°COperating Altitude4,000 m
3,200 m with ac adapterVibrationRandom, 2 g, 5 Hz-500 HzDrop1 m drop, 6 sides 

Active Network Diagnostics

FeatureDescriptionDiagnostic ProtocolsLink Layer Discovery Protocol (LLDP)
Cisco Discovery Protocol (CDP)
Fast Link Pulses (FLP)Nearest Device Diagnostics
(If available through diagnostic protocols)Switch Name
Port Number
VLAN Name
Advertised Data Rates
Advertised DuplexPower Over Ethernet CompatibilityIEEE 802.3af/at/bt
  Hardware negotiation with signature resistance
  Software negotiation with LLDP/CDPPower Over Ethernet DiagnosticsAdvertised Power Class (0 to 8)
Advertised Available Power
Powered Pairs
Diagnostics for both Single and Dual signaturesPower Over Ethernet MeasurementsLoaded Voltage (V)
Loaded Power (W)Port BlinkBlink the light of the connected port 

Cable Test Specifications

FeatureDescriptionTest PortShielded 8-pin modular jack accepts 8-pin modular (RJ45) plugs.Commissioning Autotests10GBASE-T, 5GBASE-T, 2.5GBASE-T, 1000BASE-T, 100BASE-TX, 10BASE-T, Wire map Only.
Test Speed: 6 seconds for lengths < 70 mCable TypesBalanced twisted-pair cabling
Unshielded twisted-pair
Screened twisted-pair
2-pair and/or 4-pairWire Map-Only TestsDocument wire map
Length of each pair
Diagnose split pairs
User selectable T568A or T568B
User selectable crossover settings (Straight through, Half-crossover, Full-crossover)
Test