5.0/ 5.0
100% pembeli merasa puas
2 rating • 1 ulasan
5(2)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: Sisa 3
Subtotal
Rp6.000.000
Tinkerkit Braccio robot T050000 ARDUINO ORIGINAL
Rp6.000.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Semua Etalase
Tech specs
Power
It is recommended to power the board via the jack connection with a regulated 5 VDC @ 4000 mA power supply provided in the box.
There is an on-board voltage regulator for higher voltages that protect the Braccio shield. NOTE: The protection doesn’t work for the Arduino Yun if you put the bridge between Vin and 5V on the Arm Robot Shield V1 (greater version of are called Braccio shield and has a power switch on the top of the shield)
Physical Characteristics
Plastic Parts x 21
Screws x 63
Flat Washer x 16
Hexagon Nut x 7
Springs x 2
Servo Motors: 2 x SR 311, 4 x SR 431
Arduino compatible Shield x 1
Power Supply 5V, 4A x 1
Phillips Screwdriver x 1
Spiral Cable Protection Wrap x 1
Fully assembled Braccio Kit:
Weight 792 g
Maximum operating distance range 80 cm
Maximum Height 52 cm
Base Width 14 cm
Gripper Width 90 mm
Cable length 40 cm
Load Capacity
Maximum weight at 32 cm operating distance: 150 g
Maximum weight at the minimal Braccio configuration: 400g
Braccio Shield: The maximum length and width of the Braccio Shield PCB are 2.7 and 2.1 inches respectively, with the power jack extending beyond the former dimension. Four screw holes allow the board to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.
Power
It is recommended to power the board via the jack connection with a regulated 5 VDC @ 4000 mA power supply provided in the box.
There is an on-board voltage regulator for higher voltages that protect the Braccio shield. NOTE: The protection doesn’t work for the Arduino Yun if you put the bridge between Vin and 5V on the Arm Robot Shield V1 (greater version of are called Braccio shield and has a power switch on the top of the shield)
Physical Characteristics
Plastic Parts x 21
Screws x 63
Flat Washer x 16
Hexagon Nut x 7
Springs x 2
Servo Motors: 2 x SR 311, 4 x SR 431
Arduino compatible Shield x 1
Power Supply 5V, 4A x 1
Phillips Screwdriver x 1
Spiral Cable Protection Wrap x 1
Fully assembled Braccio Kit:
Weight 792 g
Maximum operating distance range 80 cm
Maximum Height 52 cm
Base Width 14 cm
Gripper Width 90 mm
Cable length 40 cm
Load Capacity
Maximum weight at 32 cm operating distance: 150 g
Maximum weight at the minimal Braccio configuration: 400g
Braccio Shield: The maximum length and width of the Braccio Shield PCB are 2.7 and 2.1 inches respectively, with the power jack extending beyond the former dimension. Four screw holes allow the board to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.
Ada masalah dengan produk ini?