5.0/ 5.0
100% pembeli merasa puas
1 rating • 1 ulasan
5(1)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 990
Subtotal
Rp8.650.000
Moving Beam 251 New Version 3 ALPHA LED
Rp8.650.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Lighting
Moving Beam 251
Original
Safety Precaution
In order to guarantee the product's life, please don't put it in the damp places or even the
environment over 60degress.
Always mount this unit in safe and stable matter.
Install or dismantle should operate by professional engineer.
Using lamp, the change rate of power voltage should be within 10%, If the voltage is too
high, it will shorten the light's life; If it's not enough, will influence the effect.
Please restart it 20 minutes later after turning off light, until full-cooling. Frequent switching
will reduce the life span of lamps and bulbs; intermittent using will improve the life of bulbs
and lamps.
In order to make sure the product is used well, please read the Manual carefully.
Cable connection (DMX)
Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 1200hm characteristic
impedance, 22-24AWG,low capacity. Do not use microphone cable or other cable with characteristics differing
from those specified. The end connections must be made using XLR type 3 or 5-pin male/female connectors. A
terminating plug must be inserted into the last projector with a resistance of 1200hm (minimum 1/4 W) between
terminals 2 and 3.
IMPORTANT: The wires must not make contact with each other or with the metal casing of the
connectors.
Original
Safety Precaution
In order to guarantee the product's life, please don't put it in the damp places or even the
environment over 60degress.
Always mount this unit in safe and stable matter.
Install or dismantle should operate by professional engineer.
Using lamp, the change rate of power voltage should be within 10%, If the voltage is too
high, it will shorten the light's life; If it's not enough, will influence the effect.
Please restart it 20 minutes later after turning off light, until full-cooling. Frequent switching
will reduce the life span of lamps and bulbs; intermittent using will improve the life of bulbs
and lamps.
In order to make sure the product is used well, please read the Manual carefully.
Cable connection (DMX)
Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 1200hm characteristic
impedance, 22-24AWG,low capacity. Do not use microphone cable or other cable with characteristics differing
from those specified. The end connections must be made using XLR type 3 or 5-pin male/female connectors. A
terminating plug must be inserted into the last projector with a resistance of 1200hm (minimum 1/4 W) between
terminals 2 and 3.
IMPORTANT: The wires must not make contact with each other or with the metal casing of the
connectors.
Ada masalah dengan produk ini?