AT09 Android & iOS HM-10 BLE Serial Bluetooth 4.0 for Arduino

** Hai Kawan..Selamat datang di Tokopedia Rajacell ** Rata-rata semua barang di Etalase tokopedia kami READY STOCK.. Jangan ragu untuk langsung saja BELI tanpa menanyakan ketersediaan barangnya.. Kecuali jika anda ingin membeli 1 barang dalam jumlah banyak silahkan bisa bertanya jumlah stock melalui DISKUSI PRODUK atau Chat/inbox.. Terimakasih.. ** Produk serupa yang mungkin sedang anda cari : #HC-05 : https://www.tokopedia.com/rajacell/hc05-hc-05-serial-bluetooth-module-6-pin-with-anti-reverse #HC-06 : https://www.tokopedia.com/rajacell/hc-06-module-bluetooth-serial-for-arduino-hc06 #HC-06 6pin : https://www.tokopedia.com/rajacell/new-hc-06-hc06-bluetooth-module-6pin-state-en-pin-for-arduino #HC-05 Chip only : https://www.tokopedia.com/rajacell/chip-bluetooth-hc-05-serial-uart-tanpa-base-board-for-development #HC-06 Chip Only : https://www.tokopedia.com/rajacell/chip-bluetooth-hc-06-serial-uart-tanpa-base-board-for-development #SPP-C Bluetooth : https://www.tokopedia.com/rajacell/spp-c-bluetooth-serial-pass-through-module-wireless-communication #HM-10 Bluetooth : https://www.tokopedia.com/rajacell/hm10-hm-10-original-bluetooth-ble-4-0-serial-6-pin-bluetooth-module #BT-12 Bluetooth : https://www.tokopedia.com/rajacell/new-bt12-dual-mode-serial-bluetooth-module-hc0506-cc2541-ble-ios Microcontroller: TI CC2541 Size: 10cm x 6cm x 6cm Com modes: BLE Default PIN : 000000 atau 123456 AT+ command set on board Customizable baud rate, device name, and pairing PIN Automatically enters transparent serial mode after device is paired and connected Returns to AT command mode when disconnected Bluetooth version: V4.0 Default baud rate: 9600 Default serial port setting: 9600, N, 8, 1 Voltage: 3.3V VCC: 3.3~6V, (5v recomended) GND: Ground TX: transmit RX: receive State: when bluetooth is connected , output \High level\, o conntected\ output \low level nen:when module is connected, give a high level to \EN\,the module will disconnected.