ESP32-S3 WiFi Bluetooth BLE 5.0 ESP32 S3 Wifi Mesh Development Board N8R2 N16R8 - N8R2

Original ESP32 S3 Development Board 2.4G Wifi BT Module BLE5.0 ESP32-S3-WROOM-1 N8R2/N16R8 44Pin Type-C 8M PSRAM

Terdapat 2 Varian :
N8R2 : 8MB/2MB
N16R8 : 16MB/8MB

Performance:

Core: XtensaR dual-core 32-bit LX7 CPU,
frequency up to 240MHz

Memories:
384 KB of ROM
512 KB of SRAM
16 KB of RTCSRAM
8 MB of PSRAM

Working Voltage: 3 V to 3.6 V Up to 45

GPIOs
2*12-bit ADC (up to 20 channels)

Communication interfaces
2 12C interfaces
2 12S interface
4 SPI interfaces 3 UART interfaces
1 USB OTG interface

Security:
4096 bit OTP
AES, SHA, RSA, ECC, RNG
Secure Boot,
Flash Encryption,
Digital signature,
HMAC module

Extended temperature range: -40 to 65 °C

WiFi
Support IEEE802.11b/g/n protocols
Supports 20 MHZ and 40MHZ bandwidth in 24GHZ band.
Supports ITIR mode with data rate up to 150Mbps.
Wireless Multimedia (WMM)
Frame Aggregation (TX/RXA-MPDUTX/RXA-MSDU)
Immediate Block ACK (IBAC)
Fragmentation and reorganization (Fragmentation/defragmentation)
Beacon automatic monitoring(hardware TSF)
4x Virtual Wi-Fi Interface
Also supports Infrastructure BSS (Infrastructure BSS) Station Mode,
SoftAP Mode and Station+SoftAP Mixed Mode, please note that when ESP32-S3 is scanning in Station Mode, the SoftAP channel will be changed at the same time.
Antenna Diversity
802.11mcFTM
Support external power amplifier

Bluetooth
Low Power Bluetooth (Bluetooth LE): Extensions) Bluetooth 5, Bluetooth mesh
High power mode (20 dBm, shared PA with Wi-Fi)
Rate support 125 Kbps, 500Kbps, 1Mbps,2Mbps Advertising Extensions
Multiple Advertisement Sets
Channel Selection (Channel Selection Algorithm #2)
Wi-Fi and Bluetooth coexist and share the same antenna.


Advanced Peripheral Interfaces and Sensor
45 x GPIO port
Digital interfaces.
-4XSPI
-1xLCD interface (8-bit~16-bit parallel RGB, 18080, MOTO6800),
YUV422, YUV420, YUV411 conversion between each other.
-1xDVP 8-bit~16-bit camera interface
3xUART
2x12C
>- 2×12S
1X RMT(TX/RX)
- 1xPulse Counter
LED PWM Controller, up to 8
channels
-1×Full Speed USB OTG
-1×USB Serial/JTAG Controller
-2xMCPWM
-1x SDIO host interface with 2
card slots
General Purpose DMA controller (GDMA for short), 5 receive
channels and 5 transmit
channels
-1×TWA controller with ISO11898-1
(CAN specification 2.0)
Analog Interface.
-2 x 12-bit SAR ADC, up to 20
channels
-1 x temperature sensor
-14 x capacitive sensing GPIOS • Timer: - 1X RMT (TX/RX)
- 4×54-bit general-purpose
timer
-1x 52-bit System Timer
-3xWatchdog Timer