ODROID-M1 with 8GByte RAM

Specification : • SoC – Rockchip RK3568B2 quad-core Cortex-A55 processor @ up to 2.0 GHz with Arm Mali-G52 MP2 GPU, 0.8 TOPS AI accelerator • System Memory – 4GB or 8GB LPDDR4 RAM • Storage ◦ 16MB SPI flash preinstalled with Petitboot ◦ MicroSD card socket ◦ eMMC module socket ◦ Native SATA 3.0 port + SATA power (5V only) tested up to around 500 MB/s ◦ M.2 NVMe M-Key socket (2-lane PCIe 3.0) for M.2 SSDs tested up to around 1600MB/sec (or four times faster than the same SSD installed on a system based on Raspberry Pi CM4) • Video Output ◦ 1x HDMI 2.0 port up to 4Kp60 with HDR, EDID ◦ 1x 4-lane MIPI DSI connector tested with 1280×800 display • Camera I/F – 1x 2-lame MIPI CSI connector • Audio – 3.5mm headphone jack, mono speaker output (1.3W at 8Ω load) • Networking – Gigabit Ethernet RJ45 port via Realtek RTL8211F (Ethernet transceiver) • USB ◦ 2x USB 3.0 ports (or 1 x USB 3.0 host + 1 x USB 2.0 OTG port) ◦ 2x USB 2.0 ports ◦ 1x Micro USB device port • Expansion – 40-pin GPIO header • Debugging – UART header for serial console • Misc – Power button, SPI Boot Select switch, IR receiver, RTC battery holder, jumper, 2x system LEDs, M.2 LED • Power Supply – 7.5V to 15.5V via DC power jack (12V/2A adapter recommended) • Power consumption ◦ Suspend – 0.06 Watt ◦ Idle – 1.3 Watt ◦ Heavy load – 4.5Watts • Dimensions – Board: 122 x 90 x 16mm; heatsink: 123 x 100 x 19mm • Weight – 253 grams including heatsink Sources : https://wiki.odroid.com/odroid-m1/odroid-m1 Metal case : https://www.tokopedia.com/raspberrypi/m1-metal-case-kit-odroid