5.0/ 5.0
100% pembeli merasa puas
101 rating • 31 ulasan
5(99)98.02%
4(2)1.98%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 12
Subtotal
Rp197.800
Raspberry Pi RP2040-Pico
Rp197.800
Pilih warna: 3 warna
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Raspberry Pi
Varian :
# Pre Solder Header (SH) :
1x Raspberry Pi Pico - RP2040 ( header tersolder )
1x Kabel usb to micro usb
# Unsolder Header (B):
1x Raspberry Pi Pico - RP2040 ( header tidak tersolder )
# Raspberry Pi Pico W
1 x Raspberry Pi Pico W
2 x Header male 20 pin unsoldered
1 x Kabel USB to micro USB
Specification :
21 mm × 51 mm form factor
RP2040 microcontroller chip designed by Raspberry Pi in the UK
Dual-core Arm Cortex-M0+ processor, flexible clock running up to 133 MHz
264KB on-chip SRAM
2MB on-board QSPI Flash
26 multifunction GPIO pins, including 3 analogue inputs
2 × UART, 2 × SPI controllers, 2 × I2C controllers, 16 × PWM channels
1 × USB 1.1 controller and PHY, with host and device support
8 × Programmable I/O (PIO) state machines for custom peripheral support
Supported input power 1.8–5.5V DC
Operating temperature -20°C to +85°C
Castellated module allows soldering direct to carrier boards
Drag-and-drop programming using mass storage over USB
Low-power sleep and dormant modes
Accurate on-chip clock
Temperature sensor
Accelerated integer and floating-point libraries on-chip
#(W version)
Wireless (802.11n), single-band (2.4 GHz)
WPA3
Soft access point supporting up to four clients
Suport : C and MicroPython
# Pre Solder Header (SH) :
1x Raspberry Pi Pico - RP2040 ( header tersolder )
1x Kabel usb to micro usb
# Unsolder Header (B):
1x Raspberry Pi Pico - RP2040 ( header tidak tersolder )
# Raspberry Pi Pico W
1 x Raspberry Pi Pico W
2 x Header male 20 pin unsoldered
1 x Kabel USB to micro USB
Specification :
21 mm × 51 mm form factor
RP2040 microcontroller chip designed by Raspberry Pi in the UK
Dual-core Arm Cortex-M0+ processor, flexible clock running up to 133 MHz
264KB on-chip SRAM
2MB on-board QSPI Flash
26 multifunction GPIO pins, including 3 analogue inputs
2 × UART, 2 × SPI controllers, 2 × I2C controllers, 16 × PWM channels
1 × USB 1.1 controller and PHY, with host and device support
8 × Programmable I/O (PIO) state machines for custom peripheral support
Supported input power 1.8–5.5V DC
Operating temperature -20°C to +85°C
Castellated module allows soldering direct to carrier boards
Drag-and-drop programming using mass storage over USB
Low-power sleep and dormant modes
Accurate on-chip clock
Temperature sensor
Accelerated integer and floating-point libraries on-chip
#(W version)
Wireless (802.11n), single-band (2.4 GHz)
WPA3
Soft access point supporting up to four clients
Suport : C and MicroPython
Ada masalah dengan produk ini?