Download Tokopedia App
Tentang TokopediaMulai Berjualan PromoTokopedia Care
tokopedia-logo
Kategori
Atur jumlah dan catatan

Stok Total: Sisa 1

Subtotal

Rp175.000

Radiolink receiver R6FG with gyro

Rp175.000
  • Kondisi: Baru
  • Min. Pemesanan: 1 Buah
  • Etalase: Remote/Transmitter
Radiolink R6FG V4, 2.4GHz 6 channels receiver, gyro integrated and HV servo supported.
 Compatible with Radiolink 6 channels pistol grip radio RC6GS, 4 channels pistol grip radio RC4GS, RC4G, RC3S and 8 channels transmitter T8FB.
Function 
Gyro function can be enabled or disabled by press the binding button. 
Receiver with gyro integrated to hold the vehicle in a straight line during aggressive acceleration and braking or get bumped around by rough terrain. 
Receiver with gyro integrated to keep the uni-direction and anti-slip.

How to Match Code with Transmitter

1. Put the transmitter and the receiver close to each other within 50 centimeters. 
2. Turn on the transmitter, then power on the R6FG. 
3. There is a black button on the R6FG, press the binding button in one second until the receiver light starts blinking and release, after about 8 times blinking, match code success when receiver signal LED always on.
Attention: R6FG default have not turn on the gyro function. Make sure the R6FG keep motionless when power on it, because the R6FG will do the self-test. R6FG with two indicate LED, green LED on indicate normal working mode while both green and red LED on indicate gyro function working mode.


Parameters Introduction
Gyro enabled 
Gyro function is default disabled, and it enters post indication status. There are two indicators on the receiver. The green one shows the receiver status and the red one is for gyro. If both green and red LED turns on, the gyro function is enabled. If just green LED turns on while red LED turns off, gyro function is disabled.

Gyro reverse 
Same as the airplane has reverse, gyro for car has reverse as well. Reverse corrections require correct gyro reverse setup.
Gyro function setup
1. Enable Gyro
Press binding key three times (interval less than 1 second), the red LED will flash three times, indicating that gyro is enabled.
2. Gyro Reverse 
Set the gyro forward, turn the car right or left to see whether gyro functions.

Ada masalah dengan produk ini?

ULASAN PEMBELI

5.0/ 5.0

100% pembeli merasa puas

49 rating • 13 ulasan

5(49)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%