5.0/ 5.0
100% pembeli merasa puas
22 rating • 7 ulasan
5(22)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 39
Subtotal
Rp41.250
Digispark kickstarter smallest micro usb development board ATTINY85
Rp41.250
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Komponen Elektronik
Digispark USB Development Board
The Digispark is an Attiny85 based microcontroller development board similar to
the line, only cheaper, smaller, and a bit less powerful. With a whole host of
shields to extend its functionality and the ability to use the familiar Arduino
IDE the Digispark is a great way . Jump to INTO Electronics, or the when Perfect
for the Arduino AN IS TOO Big TOO much or at The Digispark IS shipped the except
for Fully Assembled at The TWO included Easy to Solder and headers. Here at The
the specs are: Support for the Arduino the IDE at The 1.0+ (OSX / the Win / the
Linux) the Power Via the USB or the Source External - 5V or 7-35v (Recommended
12V or less, Automatic Selection) the On-Board Regulator 5V 500mA Built-in the
USB . 6 the I / O Pins (2 are Used for only the USB IF your Program actively
communicates over the USB, otherwise you CAN use All. 6 the even IF you are
Programming Via the USB) 8k the Flash Memory (the About 6K the After the
bootloader) the I2C and the SPI (VIS the USI) the PWM ON 3 pins (More Possible
the with Software the PWM) the ADC ON 4 pins Power LED and Test / Status LED
The Digispark is an Attiny85 based microcontroller development board similar to
the line, only cheaper, smaller, and a bit less powerful. With a whole host of
shields to extend its functionality and the ability to use the familiar Arduino
IDE the Digispark is a great way . Jump to INTO Electronics, or the when Perfect
for the Arduino AN IS TOO Big TOO much or at The Digispark IS shipped the except
for Fully Assembled at The TWO included Easy to Solder and headers. Here at The
the specs are: Support for the Arduino the IDE at The 1.0+ (OSX / the Win / the
Linux) the Power Via the USB or the Source External - 5V or 7-35v (Recommended
12V or less, Automatic Selection) the On-Board Regulator 5V 500mA Built-in the
USB . 6 the I / O Pins (2 are Used for only the USB IF your Program actively
communicates over the USB, otherwise you CAN use All. 6 the even IF you are
Programming Via the USB) 8k the Flash Memory (the About 6K the After the
bootloader) the I2C and the SPI (VIS the USI) the PWM ON 3 pins (More Possible
the with Software the PWM) the ADC ON 4 pins Power LED and Test / Status LED
Ada masalah dengan produk ini?