Micro Inner Rotor 2430 Brushless Motor DC 6-12V (8376)

Micro Inner Rotor 2430 Brushless Motor DC 6-12V (8376)

Motor outer diameter: 24.2 MM
Motor length: 30.8 MM
Motor shaft diameter: 2.0 MM
Output shaft length: 19.5 MM
Motor cable length: over 90 MM
Motor weight: approx. 62 grams
Motor type: three-phase eight-wire with Hall (requires an external brushless driver to operate)

Voltage: DC6V
No-load current: 0.22 A
No-load speed: 5600 RPM
Voltage: DC9V (rated voltage)
No-load current: 0.22 A
No-load speed: 8500 RPM
Voltage: DC12V
No-load current: 0.22 A
No-load speed: 11400 RPM

The motor is a three-phase eight-wire brushless motor with Hall. It does not have a drive board and requires an external brushless driver to operate. We can drive it with a three-wire brushless driver (the Hall five-wire is not connected). An eight-wire brushless motor driver can also drive it. If you want to use an eight-wire driver, you should pay attention to that the signal line of the Hall and the three-phase main line of the motor must match correctly, so that the motor can operate normally, with low current, quiet sound and high torque. Powerful, if the matching is not correct, the motor may not rotate, or the current may be large and it will easily heat up, and the motor may be weak.

The eight lines are defined as follows:
Red line: Hall positive electrode (+5V)
Black line: Hall negative electrode
Yellow line: HU (Hall signal line)
Blue line: HV (Hall signal line)
Green line: HW (Hall signal line)
Orange line: U (motor three-phase main line)
Purple line: V (motor three-phase main line)
White wire: W (motor three-phase main wire)