FESTO DAPS-0060-090-R-F0507

FESTO

Feature Value
Shipping date View
Size of actuator 0060
Flange hole pattern F05
F07
Swivel angle 90 deg
End-position adjustment range at 0° -1 ... 9 deg
Shaft connection depth 16.5 mm
Fitting connection conforms to standard ISO 5211
Cushioning No cushioning
Assembly position Any
Mode of operation double-acting
Design structure Yoke kinematics
Position detection No
Closing direction right-closing
Valve connection conforms to standard VDI/VDE 3845 (NAMUR)
Safety Integrity Level (SIL) Product can be used in SRP/CS up to SIL 2 (high demand)
Product can be used in SRP/CS up to SIL 2 low demand
Operating pressure MPa 0.1 ... 0.84 MPa
Operating pressure 1 ... 8.4 bar
Nominal operating pressure 0.56 MPa
5.6 bar
CE mark (see declaration of conformity) to EU directive explosion protection (ATEX)
UKCA marking (see declaration of conformity) To UK EX instructions
ATEX category Gas II 2G
ATEX category Dust II 2D
Explosion ignition protection type Gas Ex h IIC T6...T3 Gb X
Explosion ignition protection type Dust Ex h IIIC T85°C...T200°C Db X
Explosion-proof ambient temperature -20°C <= Ta <= +60°C
Operating medium Compressed air in accordance with ISO8573-1:2010 [7:4:4]
Note on operating and pilot medium Lubricated operation possible (subsequently required for further operation)
Corrosion resistance classification CRC 3 - High corrosion stress
Ambient temperature -20 ... 80 °C
Torque at rated operating pressure and 0° rotation angle 60 Nm
Torque at nominal operating pressure with 50° swivel angle 30 Nm
Torque at nominal operating pressure with 90° swivel angle 45 Nm
Note about the torque The operating torque of the actuator must not be higher than the maximum permissible torque listed in ISO 5211, with reference to the size of the mounting flange and of the coupling.
Air consumption at 0.6 MPa (6 bar, 87 psi) per cycle 0°-nominal swivel angle-0° 2.1 l
Product weight 1,600 g
Shaft connection T14
Pneumatic connection G1/8