Zeez 2020 Stack Mpu6000 5v / 3a Bec 6uarts Osd 3-8s Zeez 45amp

Zeez F7 2020 Specifications: Mounting Holes 20×20 Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation. Up to 8S input max 36V 5V BEC up to 3A continuous STM32F722 MCU Support Betaflight, INav, Emuflight MPU6000 Gyro/ACC for smooth performance 128MB Onboard flash OSD ip Onboard 6 available UARTS VTX swit to control the ON/OFF of the VTX directly from your transmitter control via Betaflight with USER1 mode LC Filter for 5V VTX and Camera USB Type C connector Onboard RGB LED distribution for clean wiring to the LED on the arm of the quad. 8 Onboard RBG LED compliant with FAI Rules Logic Side and USB current protection Zeez ESC 4IN1 45A 2020 Specifications: Mounting Holes 20×20 3S to 6S input Constant Current: 45A Peak Current: 55A STM32L4 MCU ARM Cortex M4, 80MHz frequency BlHeli32 Firmware support Dshot150/ Dhsot300 /Dshot600/ProShot 1000 and still compatible with all older analog protocol OneShot42, OneShot125, Multishot 8 Pin JST connector and 8 Pin solder pads Holes for Aluminum Low ESR capacitor included 35V 470uF Low ESR capacitor and a spare capacitor Onboard analog current sensor Betaflight Scale: 200 ESC telemetry to read RPM and ESC temperature Compatible with Bidirectional Dshot out of the box WEIGHT AND DIMENSIONS : Weight including FCESC 8X Standoff 4X Nut 8 Pin connector : 19.9gr Dimensions: L X W X H : 41.6mm X 33.6mm X 19.6 mm Zeez 2020 STACK without LED includes: 1X Zeez F7 2020 Flight Controller 1X Zeez ESC 4in1 45A 2020 8X Aluminum Standoff 4X Aluminum Nut 1X ESC to Flight Controller 8 Pin to 8 Pin JST SH 1.00mm connector 1X ESC to Flight Controller 8 Pin to Free wires with JST SH crimp JST SH 1.00mm connector 1X ESC to Flight Controller 8 Pin to Servo Connector JST SH 1.00mm connector 1X JST SH 8 Pin Plastic Housing 1X JST SH 10 Pin Plastic Housing 2X 470uF 35V Low ESR Capacitor 1X XT60 with 12AWG Cable for battery connection 2X 2.00mm Header Pin for VTX