Hikv DS-3E1310P-EI/M Switch Hub PoE 8 Port Managed Megabit

Hikvision DS-3E1310P-EI/M Switch Hub PoE 8 Port Managed Megabit

General
Shell Metal material
Gross Weight 1.08 kg (2.38 lb)
Dimensions (W × H × D) 217.6 mm × 27.6 mm × 108.5 mm (8.57'' × 1.09'' × 4.27'')
Operating Temperature 0 °C to 40 °C (32 °F to 104 °F)
Storage Temperature -40 °C to 85 °C (-40 °F to 185 °F)
Operating Humidity 5% to 95% (no condensation)
Relative Humidity 5% to 95% (no condensation)
Power Supply DC 54 V,1.2 A
Installation Mode Desk-Mounted,Wall-Mounted
Max. Power Consumption 65 W
Power Consumption in Idle 5 W
Surge Protection 6 kV

Network Parameters
Ports 8 × 10/100 Mbps PoE port,2 × Gigabit RJ45 port
MAC Address Table 4 K
Switching Capacity
Whole-Device Performance: 9.6 Gbps
Port Performance: 5.6 Gbps
Packet Forwarding Rate
Whole-Device Performance: 7.14 Mpps
Port Performance: 4.17 Mpps
Internal Cache 2 Mbits

PoE Power Supply
PoE Standard IEEE 802.3af,IEEE 802.3at
PoE Power Pin End-span: 1/2(-), 3/6(+)
PoE Port PoE: Ports 1 to 8
Max. Port Power 30 W
PoE Power Budget 60 W

Software Function
Long Range
Ports 1 to 8: up to 300 m.
Long range performance may vary depend on camera model or cable condition.
Port Isolation
Ports 1 to 8: port isolation mode to improve network security
Ports in an isolation group cannot communicate with each other, but they can
communicate with ports outside the isolation group.
PoE Watchdog Ports 1 to 8: auto detect and restart the cameras that do not respond.
Loop Prevention
Loop prevention is used to prevent the switching network from forming loops, which
will seriously affect network communication. Disabled by default.
Support 802.1D STP.
Suppport 802.1w RSTP.
VLAN
VLAN is used for network scale planning and network health improvement.
Support 802.1Q.
Configurable VLAN ID from 1-4094.
Support Trunk, Access port mode.
Support Max. 4094 VLAN.

HPP
Support one-click activation and remote management via Hik-Partner Pro. Functions
supported:
1. Display the port rate.
2. Display the port bandwidth utilization rate.
3. Display the PoE power usage.
4. Display topology information.
5. Display the alarm status.
6. Restart ports and devices.
7. Enable port long-rage mode.
8. Remotely upgrade the device.
System Maintenance
Support device management via web.
Support DHCP Client. Enabled by default for dynamic assignment of management IP
addresses.
Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.
Support management via Hik-Central Pro.
Support remote management via Hik-Partner Pro.
Support cable detection.
Supports 802.1ab LLDP for peer device discovery.
Support port mirroring for fault locating.

Harga Sudah termasuk PPN 11%