TB6600 4 axis controller & driver Best

TB6600 4 axis controller driver personal tutorial not available

Supports MACH3, KCAM4, EMC2 etc
Can drive four channels 4.5A stepper motors, input voltage up to 18V - 40V.
Resolution 1, 1/2, 1/4, 1/8, 1/16 micro stepping output.
100% Full DC-DC optical isolation to protect the users computer and equipment.
Four channels of 0.4 - 4.5A adjustable output current for 2/4 phase bipolar stepper driver.
Build with 2 ways relay output and 5 ways limit interface
Automatic idle-current reduction.

Input Voltage12-45VDC, Recommend 24~36Vdc
Output Current Peak Current 5A/phase,
8 Options available 0.4A, 1.6A, 2.6A, 3.2A, 3.8A, 4.0A, 4.3A, 4.5A
Driving Mode Constant current PWM Control
Exciting Mode 1, 1/2, 1/4, 1/8, 1/16

Warning
Make sure the V in dose not exceed the drives input range.
Double check and make sure the cable polarity .
Do not set high current to small stepper motor. ****the motor will be damaged***
Disconnect the motor from the load if you are not sure the move direction.
Adjust the axis in the middle before trying to run the motor.
***** Never disconnect the motor lead when the power ON
***** Never make adjustment to the dip switch when the power ON

Package inclusive
Controller Driver Board, 25-pin parallel cable F/M
Manual and mach3 by email
3pcs proxi switch 6-36v 3 wires


Jangan lupa tanyakan stok terlebih dahulu sebelum order.
Kunjungi toko kami untuk melihat produk lainnya.
Layanan Pengiriman yang tersedia next day, reguler, dan cargo
Transaksi yang masuk hari Minggu dan Hari Libur Nasional akan kami proses keesokan harinya,
Terima kasih sudah berkunjung di toko kami.