Trianglelab PT1000 Pro Thermistor Cartridge M3 M4 Screw Temperature

Model Number : PT1000 Pro Thermistor M3 M4 Item Type : Thermistor Brand Name : Trianglelab Origin : Mainland China If you need to send UPS/Fedex/TNT/DHL, please contact us. We need to discuss the freight with you. The trianglelab has always been concerned about product quality. We are developing products and working hard to improve the quality. We will not abandon our reputation because of many cheap products on the market. It is believed that only high quality products can ensure the quality of your work and bring safety to your work. Some of our products may be more expensive than others, but please believe in our quality and believe that you will not regret when you receive the goods. PT1000 Pro Thermistor M3/M4 *All information can refer to PT1000 informationTrianglelab Thermistor Cartridge PT1000 Upto 450 degrees. Name: PT1000 Pro Thermistor M3/M4 Marlin Firmware Configuration: Connect directly to the thermal interface of the control board and then determine which one to choose according to the pull-up resistor of the interface. In most cases it is 4.7K ohms, please check your motherboard manual for details. * 1010 : Pt1000 with 1k pullup * 1022 : Pt1000 with 2.2k pullup * 1047 : Pt1000 with 4.7k pullup https://marlinfw.org/docs/configuration/configuration.html#thermal-settings Klipper documentation: Directly connected PT1000 sensor. The following parameters are available in heater sections that use one of these sensors. sensor_type: PT1000 sensor_pin: # Analog input pin connected to the sensor. This parameter must be # provided. #pullup_resistor: 4700 # The resistance (in ohms) of the pullup attached to the sensor. The # default is 4700 ohm