4.9/ 5.0
97% pembeli merasa puas
139 rating • 36 ulasan
5(134)96.4%
4(2)1.44%
3(0)0%
2(1)0.72%
1(2)1.44%
Diambil dari Tokopedia & TikTok Shop by TokopediaAtur jumlah dan catatan
Stok: 450
Subtotal
Rp7.800
1-Channel 5V 12V 24V DC Control Relay Switch Module with LED Indicator | Active Low Level Trigger for IoT microprocessor - 5V Relay
Rp7.800
Pilih ukuran: 5V Relay
Features:
1. With isolation groove in control area and load area.
2. With power and relay action indication, bright when connect and go off when disconnects.
3. When there is a signal in signal input, public side and common side will breakover.
4. It can be not only used as a microcontroller development board module, but also as a home appliance control.
5. It can not only control the DC or AC signal, but the 220V AC load.
6. With a permanent open and close vents contact.
7. It is convenient to connect with blue KF301 terminal access control cable.
Specification:
1. VCC: Power interface 5V
2. GND: Ground
3. IN: Control interface .Drive Current at least 4mA
4. COM: Control circuit ground ,Connect to GND
5. Trigger Mode: Low Level Trigger (0 - 1.5V)
6. Size: approx. 41 x 16 x 16mm
*Suitable for IoT, Arduino, Raspberry pi, NodeMCU / Embedded System Project or Robotic Application
*Cocok untuk IoT, Arduino, Raspberry pi, NodeMCU / Embedded System Project atau Robotic Application
**Note: Mohon ditanya terlebih dahulu untuk ketersediaan stock
1. With isolation groove in control area and load area.
2. With power and relay action indication, bright when connect and go off when disconnects.
3. When there is a signal in signal input, public side and common side will breakover.
4. It can be not only used as a microcontroller development board module, but also as a home appliance control.
5. It can not only control the DC or AC signal, but the 220V AC load.
6. With a permanent open and close vents contact.
7. It is convenient to connect with blue KF301 terminal access control cable.
Specification:
1. VCC: Power interface 5V
2. GND: Ground
3. IN: Control interface .Drive Current at least 4mA
4. COM: Control circuit ground ,Connect to GND
5. Trigger Mode: Low Level Trigger (0 - 1.5V)
6. Size: approx. 41 x 16 x 16mm
*Suitable for IoT, Arduino, Raspberry pi, NodeMCU / Embedded System Project or Robotic Application
*Cocok untuk IoT, Arduino, Raspberry pi, NodeMCU / Embedded System Project atau Robotic Application
**Note: Mohon ditanya terlebih dahulu untuk ketersediaan stock
Ada masalah dengan produk ini?
ULASAN PEMBELI
Diambil dari Tokopedia & TikTok Shop by Tokopedia