Generator Spare Parts Alternator AVR R731 Automatic Voltage Regulator

Generator Spare Parts Alternator AVR R731 Automatic Voltage Regulator

ELECTRICAL SCHEMATICS
2 typical wiring schematics are provided :
- with the CT for parallel operation on the phase U
- with the CT for parallel operation on the phase V

Input voltage :
- High voltage tap (400V) : 340V-5% to 480V=5%
- Medium voltage tap (230V) : 200V-5% to 240V+5%
- Low voltage tap (110V) : 90V-5% to 140V+5%

Internal voltage rheostat :
The voltage can be adjusted using the internal rheostat P1. This rheostat is designed to provide +/-5% adjustment from any voltage within the above voltage ranges.

Remote voltage rheostat :
If required, remove the ST10 jumper in order to connect a remote voltage rheostat.
A 470 Ohms - 3W rheostat can be used for a +/-5% voltage adjustment range or a 1k Ohms - 3W rheostat for a +/-10% voltage range.
An ST1 jumper was included on older R731 modules to increase the voltage adjustment range but was discontinued.
voltage droop
Current sensing : C.T. for // operation
- Maximum continuous current : 1.3A
- Nominal current : 1A
- Maximum current for 10s : 10A

Voltage droop rheostat :
The P2 rheostat on the R731 can be used to adjust the voltage droop. It is designed to provide a minimum voltage droop of 8% at 0 power factor and 1A from the paralleling CT.