Ethix Mr Steele Stout Motor V4 LE - Red (1pc)

I would like to Introduce the Mr. Steele V4 STOUT 2306 (1750KV) 6S FPV freestyle motor. I take great pride in my work and am always trying to raise the bar. After two years of seemingly nonstop research amp; development, I am proud to present this fine piece of Miniquad motor engineering. V4 MOTOR HIGHLIGHTS/CHANGES base redesign 16x16(only) mounting holes (structural changes for more durability) Complete bell redesigned (durability and smoothness in mind) Thicker single strand copper winding increased EFFICIENCY amp; POWER Complete Interchangeable motor pants redesign (thicker amp; more crash/low temperature resistant, better gap fitment, + more protection coverage for the “tall pants”) better assembly tolerances Overall QC improvements 9mm steel bearings Eco-Friendly packaging Motor weight 31.8g (full-length cables) compared to Stout V3 at 30.5g PANTS WEIGHTS Low - 1g vs (0.8 v3) Tall - 2g vs (1.8 v3) All in all this motor is an absolute gem only increasing the weight by a tad over 1g from the previous model while achieving more power, efficiency, and most importantly durability. V3- V4 COMPATIBILITY V4 and V3 motors are completely cross-compatible. V3 bells - V4 stator V4 bells - V3 stator ( everything is interchangeable except pants) The pants are stator-specific and can be interchangeable but with less than desired effect. Enjoy amp; Thank you for your continued support. -Steele SPECIFICATIONS Stator Size (Diameter): 23mm*6mm Kv: 1750kv Magnets: N52SH Curved Windings: 15turn DLRK Shaft Length (mm): 11.5mm Shaft Diameter (mm): 4mm Shaft material: Steel Bearing : NMB684 Weight (With Wires) (g): 32.4g Cells (Lipo): 6S Max Current (A): 45A Max Burst Current (A): 50A Internal Resistance (Rm): 100mΩ Wire Spec (AWG): 20#-135mm Base Mounting Pattern: 16x16mm Base Mounting Thread: M3 Thread Motor Overall Dimensions: φ28.6mm*17.5mm INCLUDES 1 x Motor 1 x Tall Motor Pants 1 x Short Motor Pants 4 x motor screws