4.8/ 5.0
97% pembeli merasa puas
47 rating • 19 ulasan
5(40)85.11%
4(6)12.77%
3(1)2.13%
2(0)0%
1(0)0%
Diambil dari Tokopedia & TikTok Shop by TokopediaAtur jumlah dan catatan
Stok Total: 85
Subtotal
Rp18.500
DIY Modul Sensor Getar Alarm Motor Mobil Vibration Sensor 3 Kabel
Rp18.500
Sensor Getar Alarm Mobil / Motor
Harga untuk 1pcs
Bisa untuk DIY project arduino
Automobile vibration sensor can be used for various vibration alarm sensors.
When installing, the fixing holes are installed upright on the top.
1. Output current: ≤100mA (maximum load current)
2. Quiescent current: ≤6mA
3. Rated working voltage: 12V
4. Working voltage: 5-15V
5. Cable Length: +/- 15cm
Lead description:
1. The blue line is the signal output through the 358 op amp. It is high when there is no vibration (note that the output pin must be pulled up by a resistor), and when there is vibration, it is low.
2. Red line power supply: +12V
3. The black wire is the ground wire
Harga untuk 1pcs
Bisa untuk DIY project arduino
Automobile vibration sensor can be used for various vibration alarm sensors.
When installing, the fixing holes are installed upright on the top.
1. Output current: ≤100mA (maximum load current)
2. Quiescent current: ≤6mA
3. Rated working voltage: 12V
4. Working voltage: 5-15V
5. Cable Length: +/- 15cm
Lead description:
1. The blue line is the signal output through the 358 op amp. It is high when there is no vibration (note that the output pin must be pulled up by a resistor), and when there is vibration, it is low.
2. Red line power supply: +12V
3. The black wire is the ground wire
Ada masalah dengan produk ini?
ULASAN PEMBELI
Diambil dari Tokopedia & TikTok Shop by Tokopedia