5.0/ 5.0
100% pembeli merasa puas
3 rating • 1 ulasan
5(3)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 59
Subtotal
Rp72.500
GY- OPENLOG CLEANFLIGHT NAZE 32 F3 BLACKBOX FLASH RECORDER Otg
Rp72.500
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: IOT
VCC input: 3.3V-12V (Recommended 3.3V-5V)
Log to low-cost microSD FAT16/32 cards up to 64GB.
Simple command interface
Configurable baud rates
Defaut bootloader is pro mini atmage328P 5V 16Mhz
Four SPI pogo pins
Two LEDs indicate writing status
2mA idle, 6mA at maximum recording rate
OpenLog configuration
Power up the OpenLog with a microSD card inside, wait 10 seconds or so, then power it down and plug the microSD card into your computer. You should find a "CONFIG.TXT" file on the card, open it up in a text editor. You should see the baud rate that the OpenLog has been configured for (usually 115200 or 9600 from the factory). Set the baud rate to match the rate you entered for the Blackbox in the Configurator's Port tab (typically 115200 or 250000).
Save the file and put the card back into your OpenLog, it will use those settings from now on.
If your OpenLog didn't write a CONFIG.TXT file, create a CONFIG.TXT file with these contents and store it in the root of the MicroSD card:
Log to low-cost microSD FAT16/32 cards up to 64GB.
Simple command interface
Configurable baud rates
Defaut bootloader is pro mini atmage328P 5V 16Mhz
Four SPI pogo pins
Two LEDs indicate writing status
2mA idle, 6mA at maximum recording rate
OpenLog configuration
Power up the OpenLog with a microSD card inside, wait 10 seconds or so, then power it down and plug the microSD card into your computer. You should find a "CONFIG.TXT" file on the card, open it up in a text editor. You should see the baud rate that the OpenLog has been configured for (usually 115200 or 9600 from the factory). Set the baud rate to match the rate you entered for the Blackbox in the Configurator's Port tab (typically 115200 or 250000).
Save the file and put the card back into your OpenLog, it will use those settings from now on.
If your OpenLog didn't write a CONFIG.TXT file, create a CONFIG.TXT file with these contents and store it in the root of the MicroSD card:
Ada masalah dengan produk ini?