RIGEXPERT AA-55 ZOOM ANALYSER This analyzer antenna aa55

ABOUT RIGEXPERT AA-55 ZOOM ANALYSER

This analyser is designed for measuring SWR (standing wave ratio), return loss, cable loss, as well as other parameters of cable and antenna systems in the range of 60kHz to 55MHz 

A built-in ZOOM capability makes graphical measurements especially effective. 

The following tasks are easily accomplished by using this analyser

Rapid check-out of an antenna

Tuning an antenna to resonance

Comparing characteristics of an antenna before and after specific event (rain, hurricane, etc.) 

Making coaxial stubs or measuring their parameters

Cable testing and fault location, measuring cable loss and characteristic impedance

Measuring capacitance or inductance of reactive loads

Specification

Frequency: 0.06 to 55MHz 

Frequency entry: 1KHz resolution

Measurement for: 25/50/75/100/150/200/300/450/600 ohm

SWR measurement range: 1-100 in numerical mode / 1-10 in chart mode

R&X range: 0…10000, - 10000…10000 in numerical mode /0…1000, -1000…1000 in chart mode

Dimensions: 103mm x207mmx37mm

Weight:310g (without batteries)

Operating temperature: 0-40 C (32-104 F)

Display modes

SWR at single or multiply frequencies

SWR return loss: R, X, Z, L, C and phase angle at single frequency

SWR Chart: 100 points

R X Chart: 100 points

Smith Chart: 100 points

Return loss Chart: 100 points

Cable tools (loss and characteristic impedance) 

10 slots to save measurement results

RF Output

Connector type: UHF (SO-239)

Output signal shape square 0.06 to 55MHz

Output power: +13 dBm (at 50 Ohm load)

Power 

Two 1.5V alkaline batteries, type AA

Max. 4 hours of continuous measurement, max. 2 days in stand-by mode when fully charged batteries are used

When the analyser is connected to a PC or a DC adapter with USB socket, it takes power from these sources

Interface

320×240 colour TFT display

6×3 keys on the water-proof keypad

Multilingual menus and help screens

USB connection to a personal computer