Resin UV Printer 3D LCD Anycubic Photon S 1 liter aneka warna - Abu-abu

Resin UV Printer 3D LCD Anycubic Photon S 1 liter aneka warna
Paling cocok untuk printer Anycubic Photon Series
Kapitas : 1 Liter / 1000 ml
wavelength : 405nm

Pilihan warna :
White
Black
Grey
HD Grey
Light Beige/Skin / kulit

NB: Harap tanyakan stok warna yang tersedia , sebelum order ya. Thanks

Parameter information:
UV wavelength 365-405nm
Elongation at break 12-16%
Density 1.13g/cm³
Molding shrinkage 4.5-5.5%
Viscosity 200-230 cP·mPa·s
Flexural strength 50-60 MPa
Hardness 84-86 HS
Flexural modulus 1400-1600 MPa
Tensile strength 40-50 MPa

Main material: resin monomer & photo initiator
Exposure parameters: Bottom exposure time(s) 20-60s, normal exposure time(s) 5-15s

Precautions:

Storage method:
Keep away from light seals at room temperature. (Sunshine contains a lot of UV light, will solidify photosensitive resin. After testing, the light is not affected as long as it is not UV light).
It is recommended to save at 15 ℃ -35 ℃ ambient temperature, the lower the temperature, the higher the viscosity of the resin. Sealed storage, excessive dust or moisture can affect print quality. Sunshine contains a lot of UV light, will solidify photosensitive resin.
Usage:
Shake well before use, prohibiting the use of resin in places where there is a lot of sunlight.
Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.
Inadvertent contact, as soon as possible to use a lot of water rinse. If you feel unwell, seek timely medical attention.
Printed models need to use high-concentration alcohol to clean about 30S (recommended concentration of 95% or more, the higher the better).
Do not pour the resin in the resin vat into the unused resin, do not leave the resin in the resin vat for a long time without use to avoid resin pollution affect the printing effect(long time without the resin can be introduced into airtight containers or sealed with plastic wrap shading save).