50ml Loctite 277 Thread Locking Agent Anaerobic Adhesive WulKA

50ml Loctite 277 Thread Locking Agent Anaerobic Adhesive WulKA
Kami Menyediakan Barang yang Anda Butuhkan

- Item tersedia
- Buka 24 jam, kec admin lagi ketiduran
- Hub Kami Untuk Menanyakan varian Barang
- Pengiriman cepat 6-15 hari sampai
Certification : None
Origin : CN(Origin)
DIY Supplies : Metalworking
Type : Silicone Sealant
is_customized : Yes
Model Number : 277
Specification : 50ML
color : red
Type : high strength, chemical resistance performance
Relative density : 1.1


Name: 277
Specification: 50ml
color: red
Type: high strength, chemical resistance performance
Viscosity: 6000/8000mPa.s
Average impedance: 32N.m
Average damage factor: 32N.m
Temperature range: -54/150℃
Speed: 12 hours
Recommended accelerator: 7649/7471
Relative density: 1.1
It can be used to lock the cylinder head double-threaded thread. It can be quickly cured, including prying without special surface treatment. It is recommended to produce bolts with a diameter below 1.5" (36mm). Heating and tools are required for disassembly.

Instructions
Pretreatment: Clean the surface of the assembly to ensure that there is no residual oil stains, such as engine oil, anti-rust oil, etc., and most surfaces have no special pretreatment. For difficult-to-bond substrates, cooperation must be promoted
Agent pretreatment.
Sizing: Take an appropriate amount of this product and apply it evenly on the surface of the thread.
Glue removal: The spilled glue will not solidify, just wipe it off.

Disassembly method
1. Disassemble with standard hand tools.
2. In rare cases, the bolts cannot be disassembled at room temperature due to the long mating length. The bolts can be heated locally to 250°C and disassembled while it is hot.
3. Partially heat the
HM86989