Atur jumlah dan catatan
Stok Total: 100
Subtotal
Rp2.385.700
DIY Hand Effect Maker S-ansA-m-p GT-2 Duplicate Electric Guitar Speaker Simulates Distortion of a Single Circuit Board
Rp2.385.700
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Semua Etalase
DIY Hand Effect Maker S-ansA-m-p GT-2 Duplicate Electric Guitar Speaker Simulates Distortion of a Single Circuit Board
ā³ Pre-Order +/- Sampai Alamat 15-20 Harian
DIY Supplies : ELECTRICAL
Origin : Mainland China
Certification : NONE
Origin : Mainland China
DIY Supplies : ELECTRICAL
Certification : NONE
modname=ckeditor
Note:
1, circuit board size: about 95mm*57mm15mm
2, power supply: 9v single effect device power supply
3, knob adjustment: RV1-DRIVE, RV2-LEVEL, RV3-HIGH, RV4-LOW, from left to right, are B100K
4, toggle switch: AMP, MOD, MIC
5, bare board test do not put the electric board directly on the table or the ground, otherwise it may introduce grounding will produce a lot of noise or even directly can not work normally, it is best to be able to hang the board up, leave the table or the ground.
The finished board is as follows:
:
modname=ckeditor
Note:
1, circuit board size: about 95mm*57mm15mm
2, power supply: 9v single effect device power supply
3, knob adjustment: RV1-DRIVE, RV2-LEVEL, RV3-HIGH, RV4-LOW, from left to right, are B100K
4, toggle switch: AMP, MOD, MIC
5, bare board test do not put the electric board directly on the table or the ground, otherwise it may introduce grounding will produce a lot of noise or even directly can not work normally, it is best to be able to hang the board up, leave the table or the ground.
The finished board is as follows:
:
ā³ Pre-Order +/- Sampai Alamat 15-20 Harian
DIY Supplies : ELECTRICAL
Origin : Mainland China
Certification : NONE
Origin : Mainland China
DIY Supplies : ELECTRICAL
Certification : NONE
modname=ckeditor
Note:
1, circuit board size: about 95mm*57mm15mm
2, power supply: 9v single effect device power supply
3, knob adjustment: RV1-DRIVE, RV2-LEVEL, RV3-HIGH, RV4-LOW, from left to right, are B100K
4, toggle switch: AMP, MOD, MIC
5, bare board test do not put the electric board directly on the table or the ground, otherwise it may introduce grounding will produce a lot of noise or even directly can not work normally, it is best to be able to hang the board up, leave the table or the ground.
The finished board is as follows:
:
modname=ckeditor
Note:
1, circuit board size: about 95mm*57mm15mm
2, power supply: 9v single effect device power supply
3, knob adjustment: RV1-DRIVE, RV2-LEVEL, RV3-HIGH, RV4-LOW, from left to right, are B100K
4, toggle switch: AMP, MOD, MIC
5, bare board test do not put the electric board directly on the table or the ground, otherwise it may introduce grounding will produce a lot of noise or even directly can not work normally, it is best to be able to hang the board up, leave the table or the ground.
The finished board is as follows:
:
Ada masalah dengan produk ini?
ULASAN PEMBELI
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan