Atur jumlah dan catatan
Stok Total: 31
Subtotal
Rp110.000
DIY FPV Monitor CASE 3d Print
Rp110.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: DRONE STUFF (3d Printing)
HANYA CASE 3D print, Bkn monitor
This a cheap fpv monitor enclosure. It's derivated from Dialeksi's DIA FPV with the following features :
no magnet, using a 18650 battery holder.
integrated TP4056 1S charging circuit.
way uglier design
You'll need the following parts :
LCD Screen with 5.8 VRX
This particular 18650 battery holder
Whatever 18650 battery you have/like
Switch (120V/6A ON/Off)
TP4056 charging circuit
JST 1.25 connectors
RP-SMA fpv antenna (or solder your own pigtail)
The bill of materials will take you to around 30$ (for one component of each kind).
Printing and assembly
I printed it using ABS, you have to trim it a lot in order to get correct fitting (sand paper, etc.).
Maybe it's easier with PLA.
Beware : the LCD panel is very fragile, do not bend it or force mount it or it will break.
This a cheap fpv monitor enclosure. It's derivated from Dialeksi's DIA FPV with the following features :
no magnet, using a 18650 battery holder.
integrated TP4056 1S charging circuit.
way uglier design
You'll need the following parts :
LCD Screen with 5.8 VRX
This particular 18650 battery holder
Whatever 18650 battery you have/like
Switch (120V/6A ON/Off)
TP4056 charging circuit
JST 1.25 connectors
RP-SMA fpv antenna (or solder your own pigtail)
The bill of materials will take you to around 30$ (for one component of each kind).
Printing and assembly
I printed it using ABS, you have to trim it a lot in order to get correct fitting (sand paper, etc.).
Maybe it's easier with PLA.
Beware : the LCD panel is very fragile, do not bend it or force mount it or it will break.
Ada masalah dengan produk ini?
ULASAN PEMBELI
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan