Kit Printer 3d Untuk Reprap Prusa I3 Mk3 Einsy Rambo

Logic:For Arduino MEGA compatible Atmega2560 and Atmega32u2 processors are compatible with all RAMPS class firmware Crystals for both usb and mcu (timing accurate to 10ppm) 3 Thermistor jacks + 4th Thermistor circuit on ZProbe. Motor Drivers:4 Trinamic TMC2130 1/256th microstep motor drivers(2 connectors on Z for Prusa Mendel and other dual Z printer designs) SPI Control of stepper current instead of PWM. Microstep e configured by MCU through firmware (SPI, no jumpers needed) PWM DC outputs (Extruders, Fans, Etc.) 4 outputs (1 Extruder, 1 BED, 2 low power (fan,etc) Low resistance mosfets for cool running Indicator led for each channel FANS have 3pin fan connector. FANS have 5V instead of 12-24V power source. FAN connectors have tachometer feedback pin to the MCU to measure fan speed in capable firmware. Power 2 power input rails Heated Bed, 15A 12-24V (15A dedicated fuse) Primary Power 10A 12-24V: Motors, Logic amp; Fans (5A dedicated fuse) + Extruder (5A dedicated fuse) Built in SMPS for 5V generation from the Motors, Logic amp; Fans rail Provides 5V power to FANS Connectors 4-pin motor,zprobe plug - Molex 5057-9404 3-pin fan plug - Molex 5057-9403 2-pin thermistor, mech. endstop plug - Molex 5057-9402 colour:Black Material:PCB Package Contents: 1 x Data line 2 x Gray cable 1 x Einsy Rambo 1.1b motoard 1 x 2004lcd 1 x Terminal 4 x Heat sink 1 x Adapter boardOnly the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.