Arduino LilyPad ATMEGA328 P 16M Lily Pad 328 Microcontroller Board

LilyPad Arduino adalah papan mikrokontroler dirancang untuk produk pakaian dan e-tekstil. Dapat dijahit ke kain dan juga diberi pasokan listrik, sensor dan aktuator dengan benang konduktif. Banyak dipakai oleh penghobi robot, artist, dan desainer.

The Arduino LilyPad Microcontroller Module (ATmega328) is main board consisting of an ATmega328 with the Arduino bootloader and a minimum number of external components to keep it as small (and as simple) as possible. Board will run from 2V to 5V. The latest version of the LilyPad supports automatic reset for even easier programming. The back side of the LilyPad is now completely flat! We now use a surface mount programming connector to keep the header from poking through.

This LilyPad board has 22 pins the silver petal-like tabs that ring the outside of the board twice as many as any other LilyPad Arduino. Each of these pins, with the exception of (+) and (-), can control an attached input or output device (like a light, motor, or switch). This board is based on the ATmega328V microcontroller. The microcontroller is the black square in the center of the board (top view). You can program this LilyPad board using the Arduino programming environment. See the LilyPad Arduino getting started guide for instructions on setting up your board and writing programs. See the LilyPad Arduino E-Sewing tutorial for instructions on attaching your board to fabric.

**Specification:
- Working votage: 2.7-5.5 Volts (do NOT exceed 5.5v or you will burn it)
- Total pins: 22 (20 IO pins plus power (+) and ground (-) pins)
- Digital IO pins: 20
- Analog input pins: 6
- PWM pins: 6
- Clock speed: 16 MHz
- Outer diameter: 50mm
- Thickness: 0.8mm

**Washing instruction:
Hand wash in cold water with a gentle detergent. Do not dry clean.

**Perhatian:
1. Jangan diberi tegangan lebih dari 5.5v, akan rusak terbakar
2. Jangan terbalik pemasangan positif dan negatif