IR Infrared Flame Detection Fire Detector Sensor Api arduino raspberry
Rp13.500
Product wiring instructions: 1, VCC connected to the power supply cathode 3.3-5V 2, GND connected to the negative power supply 3, DO TTL switch signal output 4, AO small board analog signal output (voltage signal)
Module Features: 1. can detect the flame or the wavelength at 760 nm to 1100 nm range of the light source, the test flame lighters distance of 80cm, the larger the flame, the greater the distance test 2. the detection angle of 60 degrees, the flame spectrum particularly sensitive 3. sensitivity adjustable (shown in blue digital potentiometer adjustment) 4. the comparator output signal clean waveform is good, driving ability, than 15mA 5. with a precision potentiometer adjustable sensitivity adjustment 6. Operating Voltage 3.3V-5V 7. the output in the form: DO digital switching outputs (0 and 1) and AO analog voltage output 8. a fixed bolt holes for easy installation 9. small plates PCB size: 3.2cmx1.4cm 10. using a wide voltage LM393 comparator
Deskripsi:
- Untuk alarm kebakaran, - Dapat mendeteksi dengan panjang gelombang pada kisaran 760 nm ~ 1100 nm dari sumber cahaya. - Semakin besar nyala api, sensor akan dengan mudah mendeteksi api. - Sudut deteksi 60 derajat, spektrum flame sangat sensitif. - Sensitivitas yang dapat disesuaikan, ditunjukkan dalam penyesuaian potensiometer. - Gelombang sinyal keluaran komparator bersih tidak noise. - Tegangan: 3.3 - 5V DC
★Paket yg didapat★
1 pcs ★ Flame Sensor Detector Detektor Api Module ★
Ada masalah dengan produk ini?
ULASAN PEMBELI
5.0/ 5.0
100% pembeli merasa puas
2 rating • 0 ulasan
5
(2)100%
4
(0)0%
3
(0)0%
2
(0)0%
1
(0)0%
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan