Relay Modul 5V 1 Channel With Optocoupler Support High and Low Trigger

Relay module 5V 1 Channel bisa trigger High dan Low tinggal pindah jumper di modul relay. Description: 1. The module uses high quality relay , normally open interfaces Maximum load : AC 250V/10A, DC 30V/10A; 2. Using patch optocoupler isolation, strong driving ability, stable performance, trigger current 5ma; The module can be triggered by a jumper to set a high or low level; Fault-tolerant design, the relay will not stop working even if the control line is disconnected; 3. The power indicator (Green) , relay status indicator (Red); 4. Module size : 50 * 26 * 18.5mm/1.97*1.02*0.73 in (L * W * H); 5. Have four mounting bolts holes , hole 3.1mm, 44.5mm * 20.5mm pitch; Technical Parameters: Quiescent current: 5mA; Maximum current: 190mA; Trigger current: 2-4mA; Low level trigger voltage: 0-1.5V; High level trigger voltage: 2.5-5V; Module Interface: 1. DC + = connect with DC 5V+; 2. DC- = connect with DC 5V - (ground); 3. IN: signal input dapat LOW atau HIGH. High and low trigger selection: 1. When the jumper is connected to LOW, it is triggered by a low level; 2, the jumper is high level when connected with HIGH Relay Outputs: 1. NO: normally open relay interfaces, relay before hanging, pull back and COM short-circuited 2. COM: Relay Common Interface 3. NC: normally closed relay interfaces, relay and COM short-circuited before, after the pull-vacan Item yang didapat: - 1x Modul relay 5V 1 channel high and low trigger ---Baca--- Catatan Toko