3.0/ 5.0
50% pembeli merasa puas
2 rating • 1 ulasan
5(1)50%
4(0)0%
3(0)0%
2(0)0%
1(1)50%
Atur jumlah dan catatan
Stok: Habis
Subtotal
-
MMA7361 Accelerometer Sensor Speed Module Compatible with Arduino
Rp50.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Electronics Part
Modul Accelerometer MMA7361
On-board MMA7361 (replace MMA7260) low cost micro capacitive accelerometer;
Support 5 V / 3.3 V voltage input, on-board RT9161, more than 1117 of the low pressure drop, faster load, very suitable for high speed corresponding noise power environment;
Range through the single-chip microcomputer IO choice, also can choose resistance;
Commonly used pins have drawn into standard needle, for 100 (2.54 mm), mil-convenient for bitmap board;
Dormancy can make by single chip IO control;
PCB board double-sided gold-plated, size: 27.9 (mm) x16.8 (mm)
This Accelerometer module is based on the popular Freescale MMA7361 three-axis analog accelerometer IC (datasheet here), which reads off the X, Y and Z acceleration as analog voltages. The accelerometer is very easy interface to an Arduino Microcontroller using 3 analog input pins, and can be used with most other microcontrollers, such as the PIC or AVR.
Features:
2x5 pin 0.1" pitch pin headers
Two sensitivity modes 1.5G and 6G
5VDC & 3.3VDC operation
0G detect pin (for linear Free-Fall detection)
Sleep Mode to save on power
Integrated 1 pole low pass filter
Temperature Compensation
Self Test Mode for easy troubleshooting
On-board MMA7361 (replace MMA7260) low cost micro capacitive accelerometer;
Support 5 V / 3.3 V voltage input, on-board RT9161, more than 1117 of the low pressure drop, faster load, very suitable for high speed corresponding noise power environment;
Range through the single-chip microcomputer IO choice, also can choose resistance;
Commonly used pins have drawn into standard needle, for 100 (2.54 mm), mil-convenient for bitmap board;
Dormancy can make by single chip IO control;
PCB board double-sided gold-plated, size: 27.9 (mm) x16.8 (mm)
This Accelerometer module is based on the popular Freescale MMA7361 three-axis analog accelerometer IC (datasheet here), which reads off the X, Y and Z acceleration as analog voltages. The accelerometer is very easy interface to an Arduino Microcontroller using 3 analog input pins, and can be used with most other microcontrollers, such as the PIC or AVR.
Features:
2x5 pin 0.1" pitch pin headers
Two sensitivity modes 1.5G and 6G
5VDC & 3.3VDC operation
0G detect pin (for linear Free-Fall detection)
Sleep Mode to save on power
Integrated 1 pole low pass filter
Temperature Compensation
Self Test Mode for easy troubleshooting
Ada masalah dengan produk ini?