5.0/ 5.0
100% pembeli merasa puas
18 rating • 3 ulasan
5(18)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 82
Subtotal
Rp24.500
Relay 24V 2 Channel Module High / Low Level Trigger Opto Isolation 2CH
Rp24.500
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Parts - Module
2 Channel 24V Relay Module With Optocoupler High/Low level Trigger relay module solid state relay module For Arduino
Spesification
1. The module uses genuine quality relay , normally open interfaces Maximum load : AC 250V/10A, DC 30V/10A;
2. Using SMD optocoupler isolation , driving ability , stable performance ; trigger current 5mA;
3. The module voltage is 24 V are available ;
4. The module can be set to high or low triggered by jumper ;
5. Fault-tolerant design , even if the control line is broken , the relay will not operate ;
6. The power indicator ( green ) , relay status indicator ( red );
7. Interface design humane, all interfaces can be connected directly via terminal wiring leads , very convenient;
8. Module size : 50mm * 41mm * 19mm ( L * W * H );
9. Has four mounting bolts holes , hole 3.1mm
- Two module interface :
1. DC +: Positive power supply ( voltage required by the relay , there 24V );
2. DC-: Negative power connection;
3. IN: Can be high or low level control relay.
- Relay outputs :
1. NO: Normally open relay interface, the relay before the vacant after the pull shorted with COM;
2. COM: Common Interface Relays;
3. NC: Normally closed relay interface relay shorted with COM ago , after the pull- vacant.
- High and low trigger selection ends :
1. short jumper with LOW LOW triggered when connected ;
2. When the jumper is high with high short trigger
Spesification
1. The module uses genuine quality relay , normally open interfaces Maximum load : AC 250V/10A, DC 30V/10A;
2. Using SMD optocoupler isolation , driving ability , stable performance ; trigger current 5mA;
3. The module voltage is 24 V are available ;
4. The module can be set to high or low triggered by jumper ;
5. Fault-tolerant design , even if the control line is broken , the relay will not operate ;
6. The power indicator ( green ) , relay status indicator ( red );
7. Interface design humane, all interfaces can be connected directly via terminal wiring leads , very convenient;
8. Module size : 50mm * 41mm * 19mm ( L * W * H );
9. Has four mounting bolts holes , hole 3.1mm
- Two module interface :
1. DC +: Positive power supply ( voltage required by the relay , there 24V );
2. DC-: Negative power connection;
3. IN: Can be high or low level control relay.
- Relay outputs :
1. NO: Normally open relay interface, the relay before the vacant after the pull shorted with COM;
2. COM: Common Interface Relays;
3. NC: Normally closed relay interface relay shorted with COM ago , after the pull- vacant.
- High and low trigger selection ends :
1. short jumper with LOW LOW triggered when connected ;
2. When the jumper is high with high short trigger
Ada masalah dengan produk ini?