Tool CJMCU-752 SC16IS752 I2C/SPI Bus Interface to Dual-channel UART

CJMCU-752 SC16IS752 I2C/SPI Bus Interface to Dual-channel UART Conversion Module Semua Produk Di Toko Kami PO (Personal Pre-Order) 7-10 Hari Tergantung Stok Dan Posisi Gudang. Harap Chat Terlebih Dahulu Sebelum Order Atau Anda Setuju Dengan Waktu Pre-Order Yang Kami Tetapkan Secara Default 15-Hari Description: SC16IS 752 is an I C bus /SPI bus connection for dual channel high performance UART Portz providing a maximum of 5Mbit/s data rate, low working and sleep current；Also for the applications additional programmable 1/0 pins are provided.Able to go from IC bus /SP I to RS-232/RS-4 Seamless protocol conversion is performed and can be done in both directions. SC16IS 752 only SPI clock speed with 4Mbit/s and IrDA SIR with maximum 1.152M bit/s support.The internal register group is backward compatible with the widely used an d popular 16C 450.Support for automatic hardware .And software flow control automatic RS-485 support and software reset.Allows software to be independent of hardware. The piece reset signal resets the UART at any time. Features •Dual-channel full-duplex UART •Optional I C bus or SPI interface •3.3V or 2.5V operation •Industrial temperature range: -40°C~+95 °C •64-byte FIFO(transmitter and receiver), receiving and sending FIFO levels .Fully compatible with industry standard 16C450 and equivalent standards .The baud rate in 16 x clock m ode is up to 5Mbit/s •Automatic hardware flow control using RTS/CTS Automatic software flow control using the programmable X on/X off character, single or two X on/X off characters •Automatic RS-485 support (automatic address detection) •A maximum of eight programmable 1/0 pins •RS-485 driver direction control via RTS signal •Reverse direction control of rS-485 drive •Built-in IrDA encoders and decoders support IrDA SIR with speeds up to 115.2kbit/s •SC16IS 762 supports IrDA SIR with a speed of 1.152kbit/s •Software reset •The sender and receiver ID-1870250