Modul converter arus ke tegangan 0-20mA to 0-3.3V 5V arduino

Spesifikasi Teknis

module ini digunakan untuk membuat tegangan variabel (bukan PWM) dari input besaran arus listrik (0~40mA).

Type Input dan output module konverter ini bisa disetting dengan soket jumper.

Pilihan input :
0~20mA
4~40mA

Pilihan output :
0~3.3V
0~5.0V
0~10.0V
*untuk mode output 0-10V VCC module harus 12V atau diatasnya.

Instruction:
1. The module is connected according to the definition, the supply voltage is 7-36V (if the output is to 10V, the supply voltage must be greater than 12V)
2. After power on, the D2 light should be bright, otherwise please check the line connection. Board with reverse connection protection, reverse connection not burning.
3. When the current input is minimum (0mA or 4mA), adjust the ZERO potentiometer, so that the output of VOUT is minimum (0.0V or other voltage)
4. When the current input is the maximum (20mA), adjust the SPAN potentiometer, so that the VOUT output is the maximum value (3.3V or 5V or 10V, when the input is 4-20mA, the minimum output can be 2.5V).

According to your needs, select the corresponding range by jumper cap:
4--20ma:0--2.5V range: J1 1, 2 feet short connection, 3, 4 feet short connection
0--3.3V range: J1 1, 2 feet off, 3, 4 feet off
0--5.0V range: J1 1, 2 feet short connection, 3, 4 feet short connection
0--10.0V range: J1 1, 2 feet short connection, 3, 4 feet off
0--20ma:0--3.3V range: J1 1, 2 feet short connection, 3, 4 feet short connection
0--5.0V range: J1 1, 2 feet short connection, 3, 4 feet short connection
0--10.0V range: J1 1, 2 feet short connection, 3, 4 feet off

Isi paket:
1 Buah Modul convetrer arus

Terima kasih telah berkunjung di klinik rasyid. Membeli berarti Setuju.
Pastikan Video Unboxing, jika ada Komplain ya