Relay 30A 1 CH 5V Trigger High Low

Relay Arus 30A maksimal
1. Modul ini mengadopsi relai 30A asli berkualitas tinggi, : AC 250V/30A, DC 30V/30A;
2. Menggunakan isolasi patch Optocoupler, Trigger 5mA
3. Tegangan operasi modul Ada 5V (Trigger)
4. Triggerbisa level tinggi (HIGH) atau rendah (LOW) melalui jumper
5. Tegangan terminal kontrol relai dan tegangan terminal pemicu dapat sepenuhnya diisolasi oleh kabel Jumper,
6. Desain toleran kesalahan, bahkan jika saluran kontrol rusak, relai tidak akan bekerja;
7. Indikator daya (hijau), indikator status relai (Merah)
8. Desain antarmuka dapat langsung dihubungkan melalui blok terminal, sangat nyaman
9. Ukuran modul: 50mm * 33mm * 24mm (panjang * lebar * tinggi),
berat bersih produk: 36g
Satu lubang baut pemasangan, lubang 3.1mm, jarak 44.5mm * 27.5mm

1.DC+: Positive pole of DC power supply of module (positive pole of trigger terminal voltage)
2.DC-: negative pole of DC power supply of module (negative pole of trigger terminal voltage)
3.IN: signal trigger terminal (default trigger voltage is the same as power supply)
4.JD+: positive pole of relay control terminal voltage
5.JD-: negative pole of relay control terminal voltage
6 .DC+ and JD+ are short-circuited with jumper caps, DC- and JD- are short-circuited with jumper caps, the trigger terminal is the same voltage as the relay control terminal
7. High and low level trigger mode selection, as shown in the figure, when the jumper is connected to L , IN terminal is low level trigger, when connected with H terminal, it is high level trigger
8. Normally closed terminal (NC): relay normally closed terminal
9. Common terminal (COM): relay common terminal
10. Normally open terminal (NO) : Relay normally open