C8051f300 Mcu Modul Papan Kontroler Mikro Untuk Kontrol Industrial

C8051F300 MCU Micro Controller Development Board Module For Industrial Control Description: Product Introduction: Analog Peripherals: 8 Bit ADC 1Up To 500ksps 2Up To 8 External Inputs 3Programmable Amplifier Gains Of 4,2,1,0.5 4VRFF From External Pin Or VDD 5Built-In Temperature Sensor 6External Conversion Start Input Comparator: 1Programmable Hysteresis And Response Time 2Configurable As Interrupt Or Reset Source 3Low Current 0.5uA On-ip Debug: -On-ip debug circuitry facilitates full speed,non-intrusive in-system debug no emulatorrequired -Provides breakpoints, single stepping,inspect/modify memory and registers -Superior performance to emulation systems using ICE-ips, target pods, and sockets -Complete development kit Supply Voltage:2.7 to 3.6 V: -Typical Operating Current:5mA 25 MHz;11uA 32MHz -Typical Stop Mode Current:0.1uA -Temperature Range:-40°C85°C High Speed 8051 Core: -Pipelined instruction aritecture; executes 70% ofinstructions in 1 or 2 system clocks -Up to 25 MIPS throughput with 25 MHz clock -Expanded interrupt handler Memory: 1.256 bytes internal data RAM -Up to 8 kB Flash; In-system programmable in 512 byte sectors Digital Peripherals: 1.8 Port I/O; All 5 V tolerant with high sink current -Hardware enhanced UART and SMBus serial ports -Three general-purpose 16-bit counter/timers 4.16-bit programmable counter array PCA with three capture/compare modules -Real time clock mode using PCA or timer and external clock source Clock Sources: -Internal oscillator:24.5MHz with /-2% accuracy supports UART operation -External oscillator:Crystal,RC,C,or clock 1 or 2 pin modes -Can swit between clock sources on-the-fly -Useful in power saving modes Board Size:31.0222.36mm