[14-C5] Relay Timer Display DC 6V~30V Delay Time Module Switch Control

Parameters: Operating voltage: DC 6V-30V (supports micro USB 5V) Trigger signal source: high-level trigger (3V-24V) signal and systematically improve the system #39;s anti-interference ability (also short-circuit altogether) Output capability: can control equipment that within DC 30V 5A or AC 220V 5A Static current: 20mA Working current: 50mA Service life: more than 100,000 times Working temperature: -40°C to 85°C Size: 6.2*3.8*1.7cm (length*width*height) Relay enable mode: 1. ON: the relay is allowed to turn on during the OP conduction time; 2. OFF: the relay is disabled and always closed. 3. Short press the STOP button on the main interface to switch between ON and OFF. The current state will flash, and then return to the main interface. (this function is an emergency stop function, one-touch disconnected relay) Operating mode: P1: after the signal is triggered, the relay turns on the OP time and then turns off; during the OP time, the following operation P1.1: signal is invalid again P1.2: signal triggered again P1.3: the signal triggers a reset again, the relay opens, and the timer stops. P2: for the trigger signal, after the relay is turned off for CL time, the relay turns on the OP time. After the timing is completed, the relay is turned off; P3.1: for the trigger signal, after the relay turns on the OP time, the relay turns off the CL time, and then it circulates the above-mentioned action. In the cycle, the signal is given again, the relay is disconnected, and the time is stopped; the number of loops (LOP) can be set; P3.2: after the power is turned on, no trigger signa