MPU-6050 MPU6050 GY-521 Gyro Accelerometer - Gyroscope

Buruan dibeli gan....barang murah-berkualitas SIAPA CEPAT DIA DAPAT Gyroscope Features The triple-axis MEMS gyroscope in the MPU-60X0 includes a wide range of features: Digital-output X-, Y-, and Z-Axis angular rate sensors (gyroscopes) with a user-programmable fullscale range of 250, 500, 1000, and 2000/sec External sync signal connected to the FSYNC pin supports image, video and GPS synchronization Integrated 16-bit ADCs enable simultaneous sampling of gyros Enhanced bias and sensitivity temperature stability reduces the need for user calibration Improved low-frequency noise performance Digitally-programmable low-pass filter Gyroscope operating current: 3.6mA Standby current: 5A Factory calibrated sensitivity scale factor User self-test 5.2 Accelerometer Features The triple-axis MEMS accelerometer in MPU-60X0 includes a wide range of features: Digital-output triple-axis accelerometer with a programmable full scale range of 2g, 4g, 8g and 16g Integrated 16-bit ADCs enable simultaneous sampling of accelerometers while requiring no external multiplexer Accelerometer normal operating current: 500A Low power accelerometer mode current: 10A at 1.25Hz, 20A at 5Hz, 60A at 20Hz, 110A at 40Hz Orientation detection and signaling Tap detection User-programmable interrupts High-G interrupt User self-test 5.3 Additional Features The MPU-60X0 includes the following additional features: 9-Axis MotionFusion by the on-chip Digital Motion Processor (DMP) Auxiliary master I2C bus for