Garden Drip Irrigation Device Pump Controller Timer System Solar

Brand Name : Studyset Origin : Mainland China Type : Watering Kits Name : Automatic Irrigation Kit features: 1. Fix the product in a position where the solar panel can be directly exposed to sunlight, the switch button side must be facing downwards. The product can be inserted into the soil by using a ground stake, or screwed to a wall, fence, etc. 2. Loosen the screws attached to the ground rod in order to adjust the angle of the solar panel surface so that the solar panel can receive as much sunlight as possible. Then tighten the screws. 3. Press the MODE button to select the watering frequency. For example, the blue indicator in the first position (upper display 12 lower display 5) indicates that the product will be watered once every 12 hours for 5 minutes. Each time the MODE button is pressed, the system will water at the first position watering frequency. 4. This product will put the long cable probe into deep water, when the water level is lower than the short cable probe (i.e. the probe is out of water), the system will automatically alarm (buzzer will sound 2 times per minute) and stop working (stop watering and timing). After refilling with water. The system will continue to work as before with the watering programme. 5. When the pump is idling, the system will sound an alarm (buzzer sounds twice a minute during the day; at night only the indicator light flashes without a beep) and the green light on the MODE button will flash. The cause of this fault may be a blocked pump or filter, please clean it, or there may be no water in the water supply container, please add water. You can turn on the pump by injecting some warm water into the pump inlet with a syringe (if required, not supplied with a syringe, please purchase separately). Once the fault has been cleared, please restart the product and the system will perform a watering and retiming. 6. When