HC-SR04 HCSR04 Ultrasonic Distance Range Sensor Jarak For Arduino

HC-SR04 Sensor Features Operating voltage: +5V Theoretical  Measuring Distance: 2cm to 450cm Practical Measuring Distance: 2cm to 80cm Accuracy: 3mm Measuring angle covered: lt;15° Operating Current: lt;15mA Operating Frequency: 40Hz How to use the HC-SR04 Ultrasonic Sensor HC-SR04 distance sensor is commonly used with both microcontroller and microprocessor platforms like Arduino, ARM, PIC, Raspberry Pie etc. The following guide is universally since it has to be followed irrespective of the type of computational device used. Power the Sensor using a regulated +5V through the Vcc ad Ground pins of the sensor. The current consumed by the sensor is less than 15mA and hence can be directly powered by the on board 5V pins . The Trigger and the Echo pins are both I/O pins and hence they can be connected to I/O pins of the microcontroller. To start the measurement, the trigger pin has to be made high for 10uS and then turned off. This action will trigger an ultrasonic wave at frequency of 40Hz from the transmitter and the receiver will wait for the wave to return. Once the wave is returned after it getting reflected by any object the Echo pin goes high for a particular amount of time which will be equal to the time taken for the wave to return back to the sensor. The amount of time during which the Echo pin stays high is measured by the MCU/MPU as it gives the information about the time taken for the wave to return back to the Sensor. Using this information the distance is measured as explained in the above heading. Applications Used to avoid and detect obstacles with robots like biped robot, obstacle avoider robot, path finding robot etc. Used to measure the distance within a wide range of 2cm to 400cm Can be used to map the objects surrounding the sensor by rotating it Depth of certain places like wells, pits etc can be measured since the waves can penetrate through water.