PLC Controller 6 Analog Input 32bit MCU 14 Input 10 Transistor Output

Specification:
Baud Rate:38400
Power Source:24VDC

Input power

DC 24V

Number of steps

8000 steps; 2 communication ports: 1 RS232 (DB9 serial communication port is FX3u protocol 38400, 7, E, 1; 1 RS485 (485 option) (communication protocol can be set D8120)

Input point X component

XO-X27, DC24 input, active low. X0-5 is the high-speed counting input port (12KHZ)

Input point Y component

YO-Y3 is the transistor output, the transistor output current is 500mA, plus the freewheeling diode can reach 4A; YO-Y3 is 4 channel 100K pulse output, the output current is 500mA, plus the freewheeling diode can reach 4A.; Y4~Y11 is the transistor common output Can directly drive 24V3A load

Analog input

6 analog inputs, 12-bit accuracy, (3 voltages 0-10V, 3 currents 0-20MA); read analog with RD3A instructions

Analog output

2 analog outputs, 12-bit accuracy, output voltage: 0-10V. Output analog voltage with WR3A command

Intermediate relay M

MO-M3071, the power-down storage range can be set to MO-M1023, the default M500-M1023

Step point S

S0-1023, the power-down storage range can be set to S0-S1023, the default S500-S9999

100Ms timer

TO-T199, cumulative power-down save T184-T199

10Ms timer

T200-T249, cumulative power-down save T246-T249

1Ms timer

T250-T383, where T250-255 is cumulative

16-bit counter

CO-C199, save power C100-199

32-bit counter

C200-C219, save power C220-C234

32-bit high-speed counter

C235-255; C235-240 is a single-phase counter, no multiplier; C241-240 is a single-phase counter, 2 times the frequency; C247-249 is a two-phase counter, no multiplier; C250-252 is a two-phase counter, 2 times Frequency; C253-255 is a two-phase counter, 4 times frequency

Register D

DO-D7999, the power-down storage range can be set to DO-7999.

Indirect addressing pointer V, Z

VO-7, Z0-7

P subroutine jump number

PO-63

I interrupt

XO-5 is interrupted outside. Timer interrupt (1MS is the unit). Counter interrupt