COOLMOON RGB Gaming LED Strip Light 5V ARGB Line for Aura Sync Motherboard Control PC Computer Case 40cm 4Pin RGB Light Strip - with controller, CHINA

COOLMOON CM-LS40 5V ARGB Small 4pin PC Case LED Light Bar SATA 3PIN Desktop Computer Lamp Strip 40cm Motherboard RGB Decoration Accessory
Feature:
Perfect atmosphere light bar can improve image clarity and alleviate eye fatigue. Bring home theater like enjoyment, very suitable for DIY.
Small 4pin+5V 3Pin ARGB male and female interface. 5V 3-pin female connector: plug into the main board 5V ARGB Shenguang synchronous interface, 5V 3-pin male connector: can be connected in series with other 5V ARGB products; Small 4PIN interface: special interface for Kuyue brand 6P controller. When the motherboard does not support 5V 3-pin ARGB, you can buy Kuyue 6P controller to use with it.
Magnetic suction installation. Convenient, practical and beautiful, it can be firmly adsorbed on the iron plate of the chassis, which is very convenient
500mm sufficient wire length. Sufficient power supply line length to meet the wiring requirements of large, medium and small chassis

Introduction of controller:
If the buyer's motherboard does not support 5V ARGB, this controller can be used to realize dimming. It does not need motherboard support. It only needs to connect the computer power SATA interface. Through the built-in lighting mode of the controller, the lighting control of 5V 3-pin ARGB products can be realized. Multiple 5V ARGB products can be inserted at the end after being connected in series to realize the lighting control of multiple 5V ARGB products
Note: this controller does not support connecting the motherboard software to control the light synchronization; This controller is not a general controller and only supports the use of products of this brand. If it is inserted into the product line sequence of other brands, it will burn out!

Specification:
Brand: COOLMOON
Lamp strip model: CM-LS40
Light strip material: ABS + magnet
Number of lamp beads: 24
Light bar interface type: 5V 4pin * 2+small 4pin * 1
Light bar interface type: 5V ARGB
Controller interface type: SATA, 3pin
Controller wire length: 3pin: 160 (±10) mm/6.3(±0.39)in; SATA;500(±10)mm/19.7(±0.39)in
Length of light strip: About 500mm/19.7in
Lamp strip size: 400 * 10 * 3mm/15.7x0.39x0.12in
Light strip weight: 20g
Controller weight: 20g
Controller size: 46x22x9.5mm/1.8x0.87x0.37in

Controller usage:
Click M to switch to the next lighting mode, which can cycle to switch the controller's own lighting mode; Click S to switch the light change speed. There are 8 gears that can be switched circularly; Long press the S key for 4 seconds to turn off the light, and then long press for 4 seconds to turn on the light; Click the C key to switch to other light colors under the same pattern or the light is reversed. Long press the C key for 5 seconds to switch the light brightness. The brightness of 6 gears in total can be reduced (cycle switching).

Note:
AURASYNC of 12V 4-pin motherboard is not supported
Be sure to disconnect the power and plug the cable, otherwise the wrong interface will cause short circuit and burn the equipment!
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-2cm measuring deviation due to manual measurement.




1 X ARGB Light Bar
or
1 X ARGB Light Bar
1 X Controller






1. WORLDWIDE SHIPPING. (Except some countries and APO/FPO)
2. Orders processed timely after the payment verification.
3. We only ship to confirmed order addresses. Your order address MUST MATCH your Shipping address.
4. The images shown are not the actual item and are for your reference only.
5. SERVICE TRANSIT TIME is provided by the carrier and excludes weekends and holidays. Transit time may vary, particularly during the holiday season.
6. If you have not received your orderafter 30 days from payment, please contact us. We will trace your order and get back to you asap. Our goal is customer satisfaction!

7. Delivery Time:


1. You have 7 days to contact us and 30 days to return it from the date received. If the item is in your possession more than 7 days, it will be considered used and WE WILL NOT ISSUEA REFUND OR REPLACEMENT to you. There are NO EXCEPTIONS!
Shipping cost is bear by both seller and buyer in half.
2. All returned items MUST BE in the original packaging and you MUST PROVIDE us with the shipping tracking number, specific reason for the return, and your order ID.
3. We will refund YOUR FULL WINNING BID AMOUNT, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER BOTH Buyer and Seller cancel the transaction from aliexpress. OR, you may choose to have a replacement.
4. We will bear all the shipping cost if the product(s) is (are) not as advertised.



1. 12 months Manufacturer’s limited Warranty for defective items (excluding items damaged and/or misused after receipt). Accessories come with a 3-month warranty.
2. Defective items MUST BE reported and returned within the warranty