Btreetech Papan Kontrol Btt V1.0 Untuk Printer 3d Voron

191415824/14428644713 On-board multiple extension functions, and added protection function to avoid damage to the motoard. Equipped with hhly ular open source firmware Marlin2.0, which is convenient for users to DIY and Secondary development. [Strong DIY Support]This motoard supports up to 8 stepper drivers with 9 stepper driver outputs in total; And up to 6 PWM fans and 2 always-on fans with the ability to individually select the voltage rail that will drive each fan. [Motoard Expansion Function]Support BLTouch, locked-rotor detection, shutdown after printing, resume printing after power failure, CAN bus, U disk function, IIC expansion; at the same time reserved WIFI interface, PT100 thermistor interface (optional), dual Z- printer. [Increase Protection Function]Uses hh-performance MOSFETs to increase heating efficiency while also reducing heat generation on the motoard. Supports #34;print from SD card #34; and #34;print via USB OTG #34; using the integrated USB-A port. Features: 1.32Bit, 180MHz, STM32F446ZET6 2.Firmware Support: Marlin, Klipper 3.Fan Interface: 6fans, 2 normally open fans 4.Support Display: BTREETECH TFT,LCD12864,LCD2004,etc 5.Adopt Type-C interface, support onprinting. 6.Reserve a dual Z- printer. 7.Support DFU to update the firmware. 8.Thermistor leakage protection. 9.Onboard EEPROM (AT24C32). 10.Reserve PT100 ule interface. 11.Support to connect to for Raspberry Pi. 12.Support U disk function, I2C expansion. Colour:Black Material:PCB+metal+electronic components Size:Appearance size: 160x100mm; installation size: 150x90mm Package Contents: 1 * V1.0 Control BoardOnly the package content, other products are not included. Note: Lht shooting and different displays m