UHU SERIES Adhesive Durable UHU Adhesive

Produk PO ya kak, estimasi kemas sampai kirim ke Indonesia lebih kurang 15-20 hari kerja, harap bersabar menunggu Super-strong (up to 170 kg/cm) Resistant to temperatures between -40 C and +100 C Filling Water resistant Chemical resistant Paintable APPLICATION SUITABLE FOR: Suitable for repairs to metal, ceramics, porcelain, crystal, glass, pearls, precious stones and various synthetics (polyester, bakelite, formica, rigid polystyrene and acrylic glass (Perspex). NOT SUITABLE FOR: Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber. HANDLING BEFORE USE: Working conditions Only apply at temperatures between +10 C and +35 C. Product cures by mixing the resin and the hardener. Personal safety Preferably wear gloves. Surface requirements The surface must be dry, clean and free of dust and grease. Preliminary surface treatment Degrease parts to be bonded with methylated spirit. Roughen smooth surfaces (sandpaper). Tools Mix the components by means of the supplied mixing bowl and spatula. Mixture ratio 1:1 Coverage 1 ml = approx 1 cm at a film thickness of 1 mm DURING USE: Directions for use Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a spatula until a mixture is obtained with a homogeneous colour. Apply the mixture, which at room temperature (+20 C) remains toolable for about 1.5 hours, as a thin layer on one of the two materials. Join the materials and keep them in place for 7 hours. Be careful not to move the parts before the adhesive has cured. Resin and hardener must not come into contact with each other unless for usage. Advice Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing. Points of attention Close well after use. For optimum performance it is important to create a larger amount of adhesive and